Activating And Deactivating Routes - roco multiMAUS PRO Handbuch

Input
/
/
Please read the third part of this manual starting on page 66 for additional information about editing or deleting
routes.

2.7.2 Activating and Deactivating Routes

1. Switch the multiMAUS
PRO
2. You can view other routes using the arrow keys.
3. Press "Light /OK" to activate a route. The turnout symbol flashes briefly in the display and the turnouts of
the route are switched. The following turnout symbol indicates activated routes:
The route remains active until it is either deleted, edited (see Part 3 "Menus"), or a turnout of the route is
switched individually.
If a turnout saved in a route is switched regardless of the route, the route is deactivated. The following turn
out symbol indicates a deactivated route:
is switched back to the position saved in the route.
The switched turnout(s) returns to the position saved in the route when the route is activated with "Light /
OK."
4. Press "Loco/Turnout" to return to locomotive mode.
The multiMAUS is switched by creating a new route or opening route mode. You now open route mode by
PRO
pressing the "Loco/Turnout" key instead of switching from the locomotive to the turnout mode. However, you
can undo this action by pressing "Shift" and "Loco/Turnout" simultaneously while in route mode (see also
Menu 4 on page 79).
Display message
Enter the next turnout after pressing Shift and the arrow keys. Continue as
with the previous steps.
to route mode (previous Chapter 2.7.1).
. However, the route is automatically reactivated if the turnout
Comment
Enter the number of the first turnout of the
route, in this case turnout number 5 set to
a branch line.
After entering the number "5", the number
flashes until the next step of the route has
been configured.
Use the arrow keys to define the direction
of travel (left arrow key = straight
right arrow key = branch
out number now stops flashing and the free
character slots are now populated with "0".
Note: The turnout is not saved if you press
only the "Light /OK" key without a config-
ured route.
Press "Light/OK" once all turnouts have
been entered. You are then returned to the
start screen.
Press the "Loco/Turnout" key to access loco-
motive mode.
.
/
). The turn-
63