Turnout Control - roco multiMAUS PRO Handbuch

2.6 Turnout control

You can use the multiMAUS
without having to use up a locomotive address (as is the case with the Lokmaus 2 /R3). To do so, you can
switch to turnout mode and back at any time by pressing the "Locomotive /turnout" key. The last turnout used
is always shown.
In addition to turnouts, it is also possible to switch other digitally controllable components such as uncoupling
tracks, signals, etc.
Drive mode is not interrupted in turnout mode. So the drive symbols of the last used locomotive are shown
on the display. However, the last locomotive to be active can be controlled using the controller and an
emergency stop can also be triggered.
Input
You use the function keys to enter the turnout address and the "arrow keys" to switch the drive to set the turn-
out to "straight-on
Straight-on
The turnouts are switched over the moment you press on of the "arrow keys". This also saves the turnout set-
ting. The first free numbers after the "T" are set as "0" as confirmation (of course, for 1, 2 or 3 digit turnout
addresses only).
The display of the turnout positions on the screen does not denote a response from the turnout drive. The
only way to check whether the turnout has actually changed is to check the turnouts themselves.
If the position of the turnout on the system does not match the display, the connection plug of the turnout
must be turned by 180°.
You can now exit turnout mode by pressing the "Locomotive /turnout" key or call up and switch another set of
turnouts by entering the address.
If you call up another turnout address, the cursor and the entered number flash alternately until the turnout
has been switched using the "arrow keys" or you confirmed by pressing the "Light /OK" key.
60
60
to control up to 2,048 digital turnout drives with genuine turnout addresses
PRO
Display message
" (left arrow key) or "branch-off
Comment
When calling up turnout control for the first time, set
of turnout 1 appears. In this case, as with every other
set of turnout called up for the first time, the complete
turnout symbol appears at the top right.
Note: The drive symbols are from the last used loco-
motive, so there can be a difference between the
shown example and your situation.
" (right arrow key).
Branch-off