Warning Signs; Typographical Emphasis; Product Information; Original Operating Instructions - Hilti AG 125-A36 Bedienungsanleitung

1 Information about the documentation
1.1 Conventions

1.1.1 Warning signs

The following warning signs are used:
General warning
1.1.2 Symbols
The following symbols are used:
Read the operating instructions before use.
Wear eye protection.
Instructions for use and other useful information
Rated speed
Revolutions per minute
Revolutions per minute
Diameter

1.1.3 Typographical emphasis

The following typographical features are used in this technical documentation:
1 These numbers refer to the corresponding illustrations.
The numbering in the illustrations reflects the order of the work steps and may deviate from the
1
numbering in the text.
1.2 Operating instructions
▶ It is essential that the operating instructions are read before initial operation.
▶ Always keep these operating instructions together with the power tool.
▶ Ensure that the operating instructions are with the power tool when it is given to other persons.
Changes and errors excepted.

1.3 Product information

Hilti products are designed for professional use and may be operated, serviced and maintained only by
trained, authorized personnel. This personnel must be informed of any particular hazards that may be
encountered. The angle grinder and its ancillary equipment may present hazards when used incorrectly by
untrained personnel or when used not as directed.
• The type designation and serial number are printed on the type identification plate.
▶ Make a note of this data in the following table and always refer to it when making an enquiry to your Hilti
representative or Hilti Service Center.
Product information
Type:
Generation:
Serial no.:
18
Printed: 14.09.2015 | Doc-Nr: PUB / 5246577 / 000 / 00
02