Operation, Precautions - Atlas Copco Cobra MK1 Sicherheitshinweise Und Betriebsanleitung

COBRA MK1, TT, TT-AWD

Operation, precautions

DANGER Explosion hazard
If a warm insertion tool and exhaust pipe comes into
contact with explosives, an explosion could occur.
During operating with certain materials, sparks and
ignition can occur. Explosions will lead to severe
injuries or death.
Never operate the machine in any explosive
►
environment.
► Never use the machine near flammable materials,
fumes or dust.
Make sure that there are no undetected sources
►
of gas or explosives.
► Avoid contact with the warm exhaust pipe or the
bottom of the machine.
Never drill in an old hole.
►
DANGER Fuel hazard
The fuel (petrol and oil) is extremely flammable and
petrol fumes can explode when ignited, causing
serious injury or death.
Protect your skin from contact with the fuel.
►
► Never remove the filler cap and never fill the fuel
tank when the machine is hot.
Mix the fuel and fill the fuel tank outdoors in a
►
clean well ventilated place, free from sparks and
open flames. Fill the fuel tank at least ten meters
(30 feet) from the place where the machine is to
be used.
Release the filler cap slowly to let pressure
►
escape.
► Never overfill the fuel tank.
Make sure the filler cap is screwed on when the
►
machine is used.
► Avoid spilling fuel and wipe off any fuel spilled on
the machine.
Check regularly for fuel leaks. Never use the
►
machine if it is leaking fuel.
► Never use the machine in the proximity of material
that can generate sparks. Remove all hot or
spark-generating devices before putting the
machine to use.
► Never smoke when filling the fuel tank or when
working with the machine or servicing it.
Only store fuel in a container that is specially
►
constructed and approved for the purpose.
► Empty fuel containers shall be taken care of and
returned to the retailer.
© 2008 Atlas Copco Construction Tools AB | No. 9800 0665 90 | 2008-10-28
Safety and operating instructions
WARNING Unexpected movements
The inserted tool is exposed to heavy strains when
the machine is used. The inserted tool may break
due to fatigue after a certain amount of use. If the
inserted tool breaks or gets stuck, there may be
sudden and unexpected movement that can cause
injuries. Futhermore, losing your balance or slipping
may cause injury.
Make sure that you always keep a stable position
►
with your feet as far apart as your shoulder width,
and keeping a balanced body weight.
Always inspect the equipment prior to use. Never
►
use the equipment if you suspect that it is
damaged.
Make sure that the handles are clean and free of
►
grease and oil.
Keep your feet away from the inserted tool.
►
► Stand firmly and always hold on to the machine
with both hands.
Never start the machine when it is lying on the
►
ground.
► Never 'ride' on the machine with one leg over the
handle.
Never strike or abuse the equipment.
►
► Check regularly for wear on the insertion tool, and
check whether there are any signs of damage or
visible cracks.
Pay attention and look at what you are doing.
►
9