Troubleshooting; Storage; Disposal - Atlas Copco Cobra MK1 Sicherheitshinweise Und Betriebsanleitung

Safety and operating instructions
13. Pull on the starting handle, check the function.
14. Pull out the starter cable, at the same time grip
the starter disc and check that if it can be turned
anticlockwise another 1/2 turn. If not, the spring
has been over-tightened and is touching the
bottom, the starter cable must therefore be
loosened a turn.
15. Fit the starting mechanism.
16. Check the function.

Troubleshooting

If the petrol breaker does not start, has low power or
runs unevenly, check the following points.
1. Check that the switch is in the ON position (A).
B
A
2. Check that there is fuel in the tank.
3. Check that the spark plug is undamaged and that
the electrode gap is 0.6–0.7 mm (0.024-0.0275
in.).
4. Check that the air filter is clean and not clogged.
5. Check that the inserted tool in use has the correct
shank dimensions.
If the machine still does not function satisfactorily,
contact an authorised workshop.

Storage

Always empty the tank before storing the machine.
♦
♦ Check that the machine is properly cleaned before
putting away for storage.
Always store the machine in a dry place.
♦
20
♦ Keep the machine and tools in a safe place, out
of the reach of children and locked up.

Disposal

A used machine must be treated and deposed of in
such a way that the greatest possible portion of the
material can be recycled and any negative influence
on the environment is kept as low as possible.
Before a petrol driven machine is deposited it must
be emptied and cleaned of all oil and petrol.
Remaining oil and petrol must be dealt with in a way
that does not affect the environment.
© 2008 Atlas Copco Construction Tools AB | No. 9800 0665 90 | 2008-10-28
COBRA MK1, TT, TT-AWD