Safety Instructions; Safety Signal Words; Personal Precautions And Qualifications; Personal Protective Equipment - Atlas Copco Cobra MK1 Sicherheitshinweise Und Betriebsanleitung

Safety and operating instructions

Safety instructions

To reduce risk of serious injury or death to yourself
or others, read these safety instructions before
operating the machine.
Post these safety instructions at work locations,
provide copies to employees, and make sure that
everyone reads the safety instructions before
operating or servicing the machine.
Comply with all safety regulations.

Safety signal words

The safety signal words Danger, Warning and
Caution have the following meanings:
DANGER
WARNING
CAUTION
Personal precautions and
qualifications
Only qualified and trained persons may operate or
maintain the machine. Always use your common
sense and good judgement.

Personal protective equipment

Always use approved protective equipment.
Operators and all other persons in the working area
must wear protective equipment, including at a
minimum:
Protective helmet
●
Hearing protection
●
● Impact resistant eye protection with side protection
Respiratory protection when appropriate
●
● Protective gloves
Proper protective boots
●
8
Indicates a hazardous situation
which, if not avoided, will result
in death or serious injury.
Indicates a hazardous situation
which, if not avoided, could
result in death or serious injury.
Indicates a hazardous situation
which, if not avoided, could
result in minor or moderate
injury.
© 2008 Atlas Copco Construction Tools AB | No. 9800 0665 90 | 2008-10-28

Drugs, alcohol or medication

WARNING Drugs, alcohol or medication
Drugs, alcohol or medication may impair your
judgment and powers of concentration. Poor
reactions and incorrect assessments can lead to
severe accidents or death.
Never use the machine when you are tired or
►
under the influence of drugs, alcohol or
medication.
► No person who is under the influence of drugs,
alcohol or medication may operate the machine.

Installation, precautions

WARNING Ejected insertion tool
If the tool retainer on the machine is not in a locked
position, the inserted tool can be ejected with force,
which can cause personal injury.
Always stop the machine before changing the
►
inserted tool.
► Never point the inserted tool at yourself or anyone
else.
Make sure that the insertion tool is fully inserted
►
and the tool retainer is in a locked position before
the machine is started.
Check the lock function by pulling the inserted tool
►
outwards powerfully.
WARNING Moving / Slipping insertion tool
An incorrect dimension of the inserted tool's shank
can result in that the inserted tool is lost or is slipping
out during operation. Risk of severe injury or crushed
hands and fingers.
Check that the insertion tool has the shank length
►
and dimensions that the machine is intended for.
► Never use an insertion tool without a collar.
COBRA MK1, TT, TT-AWD