Aerial Connection - Clatronic DVD 534 HC Bedienungsanleitung

DVD 534 HC - GB 25.06.2002 10:00 Uhr

Aerial connection

FM reception:
To connect to the house aerial or to a satellite system,
plug this cable in as the connection to the aerial socket
»FM« 50.
The aerial supplied can also produce good results. This
aerial should be fixed in a high position as possible.
AM reception:
Connect the supplied frame aerial to the »AM« 49 socket.
To plug in the cable, flip the claming lever to the side and
re-close it. Then align the frame aerial to achieve the best
reception.
Connection to the television set:
There are various connection possibilities depending on
the connections available at the television and any addi-
tional devices. Additional instructions are contained in the
respective manuals for the television and the additional
devices.
Connection to a television using SCART (A)
This connection possibility offers the best picture and so-
und quality. Connect the »SCART OUT« 46 scart socket
at the rear of the device with the television' scart socket.
The required scart cable is contained in the enclosed
package.
Note:
Connect the DVD receiver directly to the television and
not through the video recorder. The picture quality could
be seriously degraded due to copy-protection systems.
32
Seite 32
Connecting to a television via VIDEO-(B) or via the
S-VIDEO-socket (C):
(B) Connect the »VIDEO OUT« 48 video socket with the
(C) To do this, your television must be supplied with an
If you also want to hear the sound from the DVD receiver
over the speakers on your television then an AUDIO
connection (D) is also required when connecting the
video sockets. To do this, connect the »AUDIO OUT« 52
sockets with the red/white cinch cable to the correspon-
ding AUDIO IN sockets of your television. When doing so,
make sure that you maintain the correct polarity (red =
right R, white = left L).
Connecting additional units:
The DVD receiver is equipped with digital and analog out-
puts and inputs. This means that you have many possibili-
ties for connecting external devices.
Connecting to the digital outputs:
Warning: A digital audio signal is only available at these
sockets when the CD being played contains the appropri-
ate digital information. The audio output (AUDIO OUT)
has to be switched to SPDIF/RAW or SPDIF/PCM in the
menu (see »basic settings« page 35-37).
Connecting to a digital multi channel A/V receiver or
to a digital 5.1 amplifier:
This connection type offers the best sound quality. A digi-
tal multi-channel A/V receiver (e.g.. MPEG 2 multi chan-
nel, Dolby Digital etc.)is required. To do this, connect the
»COAXIAL OUT« 53 (A) digital output socket at the rear
yellow cinch cable to the corresponding VIDEO IN
socket of the television.
S-VHS input. Connect the »S-VIDEO-OUT« 47 S-
VHS video socket to the S-VHS-input at the televisi-
on. You can purchase the cable required at your local
store.