Disable / Enable Obstacle Detection; Adjustment Of The Upper Limit Position In 10°, 20°, 30; Automatic Calibration Of The Limit Positions After 120 Cycles; Test Run - heicko HREPP Serie Einbau- Und Bedienungsanleitung

Move hanging to At the upper limit position press the following button
the upper limit
position
• The bounce back function is now disabled.
• To enable the bounce back function please proceed as described above and the motor will confirm by moving briefly into both directions 2x.

14. Disable / Enable obstacle detection

• The obstacle detection stops the motor, if the hanging hits an obstacle in the downwards movement and all unwound slats of the hanging are closed
up.
• The obstacle detection is enabled in the factory default.
• The hanging may be in any position to perform this function.
Press and hold P1 whilst motor
is switched off
• The obstacle detection is now disabled.
• For enabling the obstacle detection, please proceed as described above - the motor will confirm 1x by briefly moving in both directions.
15. Adjustment of the upper limit position in 10°, 20° or 30°
• This function is only available if the upper limit was set according to 11. a) or 11. c).
• The factory setting of the motor is at 20°.
• The possible changes are, depending on the length of the hanging / bale diameter, in the range of a maximum of 2 to 10 mm.
Move hanging to
the upper limit
position.

16. Automatic calibration of the limit positions after 120 cycles

• This function is only enabled, if the limit positions are set according to 11. a). Adjustments to the upper limit position according to 15. are still possible.
• The process starts after switching on to the 120th cycle (1 cycle = 1x up and down), deletes the limit positions and and sets them again automatically.
• Deactivate automatic motor controls (e.g. timer function) if you are staying outdoors.

17. Test run

Please start a test run of the roller shutter in both directions, ensuring that the motor stops at the previously set limits.
Thermal overload protection! The motors are designed according to DIN EN 60034-1 for short-time operation (operating mode
S2 - 4 min.).
Exceeding this time or frequent switching can lead to overheating. The thermal overload protection will then automatically switch the motor off. Leave
the motor to cool down for approx. 20 minutes.
Attention! - Even a short period of continous operation (approx. 1 minute) can lead to the motor drive reaching temperatures of around 50°C. This can
further increase to approx. 100°C in the time the motor powers off (approx. 4 minutes) Let the motor cool down to room temperature otherwise a risk
of injury / burns exist, if a person comes in contact with the motor.
1 x
combination 3x: „Stop" / „Up"
x1
After pressing the button combination 3x, the motor
P1
...Then turn on the motor and wait for approx. 6
1 x
At the upper limit position press the following button combination 12x :
„Stop" / „Up"
For any further change the process must be repeated.
Example: To change from 20° to 10° the process must be repeated 2x:
20° => 30° => 10°
.....
( )
After pressing 3x...
. . . . .
)
3 x
confirms by moving briefly into both directions.
or
seconds until the motor confirms 3x.
2 x
-24-
3 x
...move the hanging to the
(
1 x
At the lower limit position press the
following button combination 3x:
„Stop" / „Down"
x 3 = disable
x 1 = enable
.....
( )
12 x
After pressing 12x...
lower limit position.
x1 = 10°
x2 = 20°
x3 = 30°