Deleting Of Limit Positions - Factory Setting; Disable / Enable The Bounce Back Function Of The Obstacle Detection - heicko HREPP Serie Einbau- Und Bedienungsanleitung

d) Manual setting of the upper limit position and automatic setting of the lower limit position via setting device HR130020
Start from a Press „Up"
central position
12. Deleting of limit positions - factory default
• It is required to use this function if the limit positions are supposed to be set automatically via Plug & Play function again.
a) Deleting the limit positions with the direction switch and the setup button P2 of the setting device HR130020
• When using this function the hanging can be stopped in any position.
• If the hanging is stopped at a limit position, after pressing the setup button P2 the direction button of the corresponding limit position needs to be
pressed (at the upper limit position = „Up" button, at the lower limit position = „Down" button). After the deleting process is finished, the hanging will
move approx. 10 to 20 cm (depending on the length of the hanging) apart from the corresponding limit position - see below. We recommend not to use
this method at a limit position. Otherwise malfunctions may occur.
P2
Press P2 and hold, press „Up" and
wait 12 seconds until the motor
confirms 1x...
b) Resetting to factory default with the direction switch of the setting device HR130020
• This function resets all settings / changes.
• This method can also be used with any shutter switch, if the motor is already installed.
Move hanging to the
upper limit position
8 x
After pressing the button combination
for 8x, the hanging will move approx.
10-20 cm upwards.
Afterwards switch off the setting
device for at least 10 seconds.
• Method b) can also be started at the lower limit position. At the end of the process the hanging will move approx. 10-20 cm downwards from the upper
limit position.

13. Disable / Enable the bounce back function of the obstacle detection

• The obstacle detection stops the motor, if the hanging hits an obstacle during the downwards movement and all unwound slats are closed up. The
motor will automatically wind up approx. half a rotation of the hanging. This distance depends on the bale diameter of the hanging.
• The bounce back function is enabled at the factory default.
x1
Hanging moves to the
lower rabbet...
x1
12 Sec.
...then let go of P2 and the
hanging will move approx. 10 -
20 cm downwards.
Afterwards switch off the setting
device for at least 10 seconds.
1 x
At the upper limit position press the following button combination 8x :
„Stop" / „Up"
. . . . .
) (
2 x
...the automatically ...stop at your desired upper
upwards... limit position...
Both limit positions are now set and saved.
The rotation direction is now correct,
according to the switch position.
P2
or
Press P2 and hold, press „Down" and
wait 12 seconds until the motor
confirms 1x...
2 x
1 x
At the lower limit position press the following
button combination 8x:
„Stop" / „Down"
-23-
P2
...then press P2 and hold, press
„Up" and wait for 6 seconds
until motor confirms 1x...
...then let go of P2
and the motor will confirm 2x...
x1
12 Sec.
...then let go of P2 and the
hanging will move approx. 10 -
20 cm upwards.
Afterwards switch off the setting
device for at least 10 seconds.
.....
( )
8 x
After pressing 8x...
...move the hanging to the
lower limit position.
x1
6 Sek.
x2