Faults - Atag HIK 271 Gebrauchsanweisung

F A U LT S
Please check the following points which may solve the problem, before calling the engineer (page 54).
SYMPTOM
The appliance does not work. The
lights do not light up
The cooking zones are not working,
the message appears
The fan switches itself on
The appliance stops suddenly
The message appears
The lamps continue to flash after
switching on
50
CAUSE
No power supply
Ambient temperature too low (5 ° C)
before the hob was plugged in
The appliance checks itself after the
loss of power
Ventilator is not far enough open
Transistors overheated
Contact between pans/wall
An unsuitable utensil is being used
Poor electrical connection
ACTION
Check the electrical installation
(fuse(s), connection)
After installation, wait about ten
minutes. The messages stop
flashing and you can then use the
appliance
The fan switches itself off
Check ventilator openings at front
and back
Press any control. The message
disappears. Restart at a lower
setting
Place pans apart
Use a suitable utensil. See page 37
Check if the cable is being caught by
the drawer. If it is, have it changed
by the installer