General Operation - VWR Bead Mill Benutzerhandbuch

1.
2.
3.
4.
5.
1. Program Number
2. Speed
3. Cycle Time
4. Navigation Buttons
5. Parameters Adjustment Buttons
Language Setting
Turn unit OFF. Press and hold
 
to select.
Choose from French, English, German, Italian, or Spanish.
Programming Mode
 UP and  DOWN - navigate through menu.
 LEFT and  RIGHT - adjust the parameters.
PARAMETER
S
Speed / Energy
T
Time
C
Number of Cycles
Dwell
D
(Pause between Runs)
- When the settings are entered, press up
- Press "Run" to start.
- At the end of the program "DONE" will be displayed followed by "REMOVE SAMPLES".
- If run is stopped system status will read "PROGRAM PAUSED".
- Pause or Stop a run anytime by pressing the "STOP" button.
- Press "STOP" again to cancel current run.

General Operation

PROG 01
S =4.50
T=0:10

while powering on unit.
OPERATING RANGE
From 0.8 m/s to 6.5 m/s
From 0:01 to 9:59 in increments of
1 second
1 to 10
0:01 to 9:59
 or down
20 o C
C=02
D=0:10
READY
6. Processing Chamber Temperature
7. Number of Cycles
8. Dwell or Time interval between cycles
9. Run Button
10. Stop Button
 to return to the program option.
6.
7.
8.
9.
10.
6