Vitek VT-1645N GY Betriebsanweisung Seite 4

ENGLISH enGLish
Mini-chopper
description of the device
1. The ON button
2. Motor unit
3. Cover
4. Upper chopping blade (additional)
5. Lower chopping blade (main)
6. Chopper bowl
7. Fixed shaft (blade support)
sAfetY MeAsUres
Before using the mini-chopper for the first time, make sure that the power supply voltage corre-
sponds to the voltage specified on the device casing.
• In order to prevent electric shock, never immerse the motor unit into water or other liquids. Do not
use the device near to tabs filled with water, do not touch the motor unit with wet hands.
If the device has fallen into the water:
• Do not immerse your hand into the water.
• Immediately disconnect the device from the power network.
• Before continuing to use the device, apply to the authorized service center for its inspection (or
repair, if necessary).
• Do not use the device outside.
• Never leave the device without supervision if it is connected to the electric network!
• Always disconnect the device from the power network, when installing or removing accessories,
cleaning the device or when any malfunctions occur.
• When disconnecting the device from the electric system, always hold by the cord plug, never pull
the power cord.
• During the work, place the device in the places inaccessible to children or persons with limited
capabilities.
• Never use the device near hot surfaces.
• BE CAREFUL WITH BLADES, THEY ARE VERY SHARP.
• The device is intended for domestic purposes. the continuous operating time of the device
should not exceed 10 seconds, after which time you should stop the device and wait until
the electromotor is fully cooled down.
• Do not use the device with a damaged power cord or plug if the device operation is faulty, if it has
been dropped or damaged otherwise.
• Do not disassemble or repair the device yourself, always apply to the authorized service center.
Before the first Use
Take the device from the packing and remove all packing materials, wipe the motor unit (2) with a
damp fabric, and wash the chopper bowl (6), the cover (3) and blades (4), (5) in warm soap water,
then rinse and dry up.
UsinG the device
1. Put the chopper bowl onto an even dry surface .
2. Attach the additional blade (4) to the main blade (5), the way indicated on (Fig.2).
3. Install the blades (5) and (4) onto the axis in the center of the bowl (7), (Fig 2 B).
4. Load the products into the chopper bowl. If necessary, cut them into the slices of smaller (about
the same) size. Make sure that the levels of liquids that were added into the bowl or that have
formed as a result of product chopping, do not exceed the top maximum level mark indicated on
the chopper bowl.
5. Close the chopper bowl the cover (3), having aligned the protrusions on the cover with the grooves
on the bowl (the device will not turn on, if the cover is not installed) .
1645.indd 4
4 4
26.11.2013 16:12:56