Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MVE
C
3.Presence of harmful powders
Operators who access certain dust treatment processes involving the presence of harmful substances during routine and unscheduled
operations must wear suitable protective equipment as specified in the safety data sheet of the product processed by the equipment inside
which the motovibrator is inserted.
4.Hot surfaces
The surface temperature of the motovibrator is greater than the burn threshold. The risk of burns exists. The internal surface of the
motovibrator cannot be touched during normal operation and in case of maintenance. Wait for it to cool down to a temperature not
exceeding 55°C (130°F)
Before going ahead with the scrapping of the electric motovibrator, thoroughly clean it and dispose of residual dust in accordance with the
instructions on the safety data sheet.
The machine must be dismantled in a zone classified as safe.
The operators in charge of disposal must wear suitable personal protective equipment.
The electric motovibrator must be demolished so that it can no longer be reused as a complete unit and that one or several of its parts
cannot be reused. In the event of disposal of the spent grease of the motovibrator, it is mandatory to comply with the legislation in place
in the country where you operate. In the event of scrapping at the end of the machine's service life, ensure you disassemble the various
plastic parts (gaskets) and send them to the designated collection centres. The remaining parts must be intended for the recovery of
ferrous materials.
With reference to the WEEE directive, electrical and electronic components marked with the designated symbol must be disposed of in
dedicated authorised collection centres.
The illegal disposal of "Waste Electrical and Electronic Equipment" (WEEE) is punishable with sanctions regulated by applicable laws in
force.
2.11 - RETURNING THE MACHINE
In case of return of the machine, place it back into the packaging if retained or back into a box, trying to protect it as best as possible from
any shocks due to transport. In any case, ensure the machine does not have any residues of material.
2.12 - DECLARATION OF CONFORMITY
The equipment comes with a declaration of conformity with current directives, though, if it is integrated into a more complex system, its
safety is associated with compliance by the installer with all applicable directives. Any improper use of the electric motovibrator without
following the instructions in this manual shall relieve OLI® from any liability related to malfunctions of the electric motovibrator. As this is
an area undergoing strong technical and regulatory development, OLI® reserves the right to update, as quickly as possible, its product with
all the technological knowledge and applicable official standards (EN, UNI) that might become available as and when.
PLEASE NOTE With reference to the "MACHINERY DIRECTIVE 2006/42/EC", the following
declaration shall be intended as a "declaration of incorporation" under art. 4.2 paragraph 1 and
Annex II.B.
REV.01 | 01/2019
CM
US
Intertek
!
2.10 - SCRAPPING THE MACHINE
2
M. 58
Werbung
Inhaltsverzeichnis
