Operating Instructions - OLI MVE J Serie Handbuch

MVE
C
_ _ _
_ _ _ _ _
MVE
!
Do not tamper with the machine with any device to obtain performance levels that differ from those in the project.
Any unauthorised change can affect the health of people, as well as compromise the integrity of the machine itself.
Operators must only wear protective clothing and be equipped with personal protective equipment suitable for carrying out operations
and required by the safety and accident-prevention standards.
Before use, make sure that all safety devices have been installed and are in good working order.
Only authorised personnel must access the work area during operation.
Remove any obstacles or sources of danger from the operating area.
Connect the vibrator to the power supply by means of cables that have an operating temperature matching the value reported on the
rating plate of the motovibrator or on the warning label.
MVE motovibrators are supplied with cable glands compliant with directive 2014/34/EU according to category 2D with an IP66 protection
rating.
If they need to be replaced, use cable glands with the same characteristics.
The motovibrator described in this manual has been designed and tested for use in potentially explosive areas classified as:
- Zone 21 in accordance with IEC 60079-10-2, CEC.CSA C22.1 art.18 and in accordance with ATEX directive 2014/34/EU.
- Class II DIV.2 in accordance with NEC article 500.5 of the National Electrical Code.
The user must ensure that the workplace where the motovibrator will be installed has been suitably made safe against explosion hazards.
At the time of order the client must specify the characteristics of the powders to be treated and the process temperatures as well.
IMPORTANT: the ATEX version of the motovibrator is designed to operate with powders that do
not release explosive gases during the processing
FOLLOW THE INDICATIONS REPORTED ON THE RATING PLATE: D = dust (group IIIC)
To ensure you operate under safe conditions ensure that:
-The processed powders have an ignition temperature 75K higher than the surface
temperature indicated on the rating plate of the motovibrator (IEC 60079-10-2).
-For the Class II Div.2 certification, the rating plate specifies the dust groups (F, G) and the
operating temperature class (NEC 500.8).
(The maximum temperatures indicated in this manual and on the rating plate of the
motovibrators have been calculated without considering the presence of any layers of dust
deposited on the surfaces).
The electric vibrator must be installed with enough space to carry out normal assembly/disassembly, cleaning and maintenance
operations.
REV.01 | 01/2019
CM
US
Intertek
_ _ _ _ _ _ _ _ _

1.4 - OPERATING INSTRUCTIONS

-80A- = Size of the motovibrator and bore (full list of models in the TAB section)
--- = Motovibrator series (Empty foot range motorvibrator)
J/H/E = Certification
3 = 3000 max rpm – 36 = 3600 max rpm
15 = 1500 max rpm – 18 = 1800 max rpm
1 =1000 max rpm – 12 =1200 max rpm
075 =7 50 max rpm – 090 =950 max rpm
Max CF from 20 to 26400 kg. For the US market from 48 to 58300 Lb (three-phase motors)
Max CF from 66 to 323 kg. For the US market from 71 to 712 Lb (single-phase motors)
Internal code: Electric motovibrator
1
T. 38
2 = 2 poles (3600 rpm)
For the
4 = 4 poles (1800 rpm)
US market
6 = 6 poles (1200 rpm)
8 = 8 poles (900 rpm)
!