Residual Risks; Charging The Battery; Inserting/Removing The Battery; Recharging The Battery - Parkside PMSA 12 A1 Originalbetriebsanleitung

Residual risks

Even if properly operating and
handling this electric tool, some
residual risks will remain. Due
to its construction and build, this
electric tool may present the fol-
lowing hazards:
a) Cuts
b) Hearing damage if suitable
ear protection is not worn.
c) Health injuries which result
from swinging hand and
arm, in the
device is used over a longer
period of time or is not used
and maintained properly.
Warning! During opera-
tion, this electric tool gen-
erates an electromagnetic
field which, under certain
circumstances, may impair
the functionality of active or
passive medical implants.
To reduce the risk of serious
or lethal injuries, we rec-
ommend that persons with
medical implants consult
their doctor and the manu-
facturer of their medical
implant before operating
the machine.

Charging the battery

Do not expose the battery to
extreme conditions such as
heat or impact. Risk of injury
from escaping electrolytic so-
lution! After eye/skin contact,
rinse the affected areas with
water or a neutraliser and
consult a doctor.
event that the
GB
Charge the battery in a dry
room only.
Prior to attaching the charger,
check that the battery's outer
surface is clean and dry.
There is a risk of injury due
to electric shock.
Only use the original charger from
the package to charge the battery.
Make sure that the power supply
voltage matches the voltage rating
indicated on the device's type plate.
• Charge the battery before the first time
of use.
• Recharge the battery when you notice
that the appliance is becoming slower.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM spare
battery available from our Customer
Service.
Inserting/removing the
battery
1. To insert the battery (9), place it on the
guide track and push it back into the
appliance. It will audibly snap in.
2. To remove the battery (9) from the ap-
pliance, press the release buttons (10)
on the battery and pull out the battery.

Recharging the battery

1. Remove the battery (9) from the appli-
ance i necessary.
2. Insert the battery (9) in the charging
compartment of the battery charger
(18).
IE NI CY
13