Supplementary Notes; Original Accessories/Auxiliary Equipment; Residual Risks; Working Procedures - Parkside PDFS 1300 A1 Originalbetriebsanleitung

j) Be particularly careful when making pocket
cuts into existing walls or other obscured areas.
The inserted cutting disc may cut into gas or
water pipes, electrical wiring or other objects
that can cause a kickback.
k) Position your body on one of the two sides of
the cutting disc, but not in line with the cutting
disc.

Supplementary notes

Wear ear muffs!
Wear safety goggles!
Wear safety shoes!
Wear protective gloves!
Wear a dust mask!
Not approved for side grinding
Original accessories/auxiliary equip-
ment
■ Use only the accessories and additional
equipment that are specified in the operating
instructions and are compatible with the
appliance.

Residual risks

Despite compliance with the applicable safety reg-
ulations and the use of protective devices, certain
risks cannot be avoided. These are the following:
■ Hearing loss
■ Risk of injury due to flying fragments
■ Risk of burns due to accessories becoming hot
during operation
■ Risk of injury due to prolonged use.
│ GB │ IE
■ 22

Working procedures

■ Secure the workpiece. Use clamps/a vice to
hold the workpiece firmly in place. This is much
safer than simply holding it in your hand.
■ Materials containing asbestos may not be
processed. Asbestos is a known carcinogen.
Tip! This symbol indicates proper
behaviour.
DANGER! ALWAYS GUIDE THE
APPLIANCE THROUGH THE WORK-
PIECE IN REVERSE ROTATION.
► In the opposite direction there is a risk of
kickback. The appliance can be pushed out
of the cut.
■ Always hold the appliance firmly with two
hands while working. Ensure that your stance
is secure and stable.
■ When working on angled surfaces, do not
exert great force on the workpiece. If the
rotational speed drops significantly, you must
reduce the pressure exerted to allow safe and
effective working. If the appliance suddenly
brakes completely or jams, it must be switched
off immediately.
■ Cutting: Work with a moderate feed and do
not tilt the cutting disc.
■ Cutting discs become very hot when work-
ing – let them cool down completely before
touching them.
■ Never use the appliance for purposes other
than those for which it was designed.
■ Remain alert at all times! Always pay atten-
tion to what you are doing and act with com-
mon sense. Do not use the appliance if you are
distracted or feeling unwell.
PDFS 1300 A1