Switching Off The Roof Air Conditioner; Selecting The Room Temperature; Selecting The Operating Mode - Waeco CoolAir CA-1000-AC Einbau- Und Bedienungsanleitungen

_CA-1000.book Seite 46 Freitag, 28. Juli 2006 10:35 10
Operation
6.4

Switching off the roof air conditioner

➤ With the system switched on, press the ON/OFF button (see
fig. 15 on page 7, 1).
✓ The LEDs and digital display go out.
✓ A dot on the display shows that the air conditioner is ready for
operation.
✓ The fan and the compressor switch off.
6.5

Selecting the room temperature

You can select temperatures between 17 °C and 30 °C.
➤ With the system switched on, press the + or - button (see
fig. 15 on page 7, 6 and 7) to select the room temperature in 1 °C steps.
✓ The digital display (see fig. 15 on page 7, 5) shows the operating
mode and the selected room temperature in °C.
If the selected temperature is not reached in Mode I, change to the next
higher mode or to automatic mode.
6.6

Selecting the operating mode

You can choose between 3 operating modes:
Operating
mode
1
2
Automatic
➤ With the system switched on, press the Mode button (see
fig. 15 on page 7, 4) to select the operating mode.
✓ The first digit of the display (see fig. 15 on page 7, 5) shows the
selected mode and the second and third show the selected room
temperature in °C.
46
Display Explanation
message
Lowest power level – the fan runs at the lowest speed
until the set room temperature is reached.
Highest power level – the fan runs at the highest
speed until the set room temperature is reached.
The system automatically selects the optimum fan
A
speed to reach the set temperature most efficiently.
CoolAir