Setting The Air Nozzles; Remote Control - Waeco EasyCool series Einbau- Und Bedienungsanleitung

_ec_2500-3000.book Seite 56 Freitag, 29. April 2005 4:05 16
Operation
Do not insert any fingers or objects into the air distribution nozzles or the
intake grille.
6.2

Setting the air nozzles

– see fig. 11 on page 6 –
Never close all of the air nozzles of the roof air conditioner simultaneously.
The device would freeze from within and the icing sensor would switch off
the device.
The air supply within the vehicle can be regulated by opening or closing
the air nozzles (see fig. 11 on page 6, pos. 1 and 2).
The lateral air nozzles (see fig. 11 on page 6, pos. 1) can be set to an
angle of approximately 120° in order to divert the air stream in the desired
direction.
➤ Open or close the air nozzles to regulate the air current as desired
everywhere within the vehicle.
➤ Set the desired air current outlet angle using the wheel of the lateral
air nozzles.
6.3

Remote control

– see fig. 12 on page 6 –
All settings of the device (timer programming, temperature setting etc.) are
transmitted to the system by remote control.
If your roof air conditioner is equipped with mobile air conditioning
(EC-2500-AC/DC and EC-3000-AC/DC only) and not connected to a
230-V-power source, the remote control can only be used if mobile air con-
ditioning has been switched on by means of the DC On/OFF key on the
control panel (Refer to the "Control panel" section on page 61).
56 Installation and operating manual
EasyCool