Handling Electrical Cables; Conventions In This Manual; General Information On The Manual - Waeco CoolAir CA-1000-AC Einbau- Und Bedienungsanleitungen

_CA-1000.book Seite 31 Freitag, 28. Juli 2006 10:35 10
CoolAir
Please ask your vehicle manufacturer if a technical inspection is
required after fitting an air conditioner and whether the height entered in
your vehicule documents needs to be altered (increased height
199 mm).
If faults occur in the system's refrigerant circuit, the system must be
checked by a specialist company and properly repaired. The refrigerant
must never be released into the air.

1.1.1 Handling electrical cables

Use cable ducts to lay cables through walls with sharp edges.
Do not lay loose or bent cables next to electrically conductive materials
(metal).
Do not pull on the cables.
Attach and lay the cables in such a manner that they cannot be tripped
over or damaged.
The electrical power supply may only be connected by a qualified
electrician (e.g. VDE 0100, Part 721 in Germany).
Fit a fuse of at least 16 amps to the connection with the vehicle's power
supply.
2

Conventions in this manual

2.1

General information on the manual

This manual contains essential information and instructions for the proper
use and installation of the roof air conditioner. This information is intended
both for the user and the company installing the roof air conditioner.
The following instructions are intended to help you use the manual
properly:
The manual is part of the scope of delivery and should be stored
carefully.
The proper use described in this manual ensures economical operation
and a longer service life of the device.
The installation manual provides important information on installing the
device and can also be used as a reference for repairs.
The manufacturer (WAECO) assumes no liability for non-observance of
this manual. Any claims are excluded in this case.
Conventions in this manual
31