Operation; Setting The Air Nozzles - Waeco CoolAir CA-1000-AC Einbau- Und Bedienungsanleitungen

_CA-1000.book Seite 44 Freitag, 28. Juli 2006 10:35 10

Operation

6 Operation
The manufacturer assumes no liability for non-observance of this
operating manual, in particular for any consequential damage, especially
consequential damage caused by failure of the air conditioner.
Do not insert your fingers or objects into the air distribution nozzles or the
intake grille.
Observe the following instructions for use to ensure your WAECO roof air
conditioner is used efficiently:
Avoid opening doors and windows as far as possible during cooling.
Align the air distribution nozzles.
Do not close the air distribution nozzles completely.
Select an appropriate temperature and air speed.
Make sure the air distribution nozzles 4 and intake grille (see
fig. 14 on page 7) are not covered by cloths, paper or other objects.
6.1

Setting the air nozzles

Never close all of the air nozzles of the roof air conditioner at the same
time. The device would ice up inside.
The air supply within the vehicle can be regulated by opening or closing
the air nozzles (see fig. 14 on page 7).
➤ Open or close the air nozzles to regulate the air current as desired
everywhere within the vehicle.
➤ Adjust the air outlet angle by turning the nozzles.
44
CoolAir