Safety Instructions; Electrical Supply - Merrychef Mealstream serie Handbuch

IMPORTANT SAFETY INSTRUCTIONS
PLEASE READ THE FOLLOWING SAFETY INSTRUCTIONS CAREFULLY
WARNING:
It is hazardous for anyone other than a skilled person to carry out any service or repair operation
which involves the removal of any cover which gives protection against exposure to microwave energy
1. DO NOT operate empty, without food or liquid inside the oven, as this will result in overheating and may
cause damage.
2. NEVER remove any fixed internal parts of the oven.
3. NEVER tamper with the control panel, door, seals, or any other part oven.
4. DO NOT obstruct air vents/filters or steam outlet.
5. NEVER hang tea towels or cloths on any part of the oven.
6. If the door seals are damaged, the oven must be repaired by an approved Engineer.
7. If the power cable is damaged in any way it MUST be replaced by an approved Engineer.
8. When handling hot liquids, foods, and containers, care should be taken to avoid scalds and burns.
9. When heating liquids using microwave only or combination function, the contents should be stirred prior
to heating to avoid eruptive boiling.
10. Feeding bottles and baby food jars should be opened when heating, the contents stirred or shaken and
the temperature checked prior to consumption to avoid burns.
11. Never use the oven to heat alcohol, e.g. brandy, rum etc. Also, food containing alcohol, such as
Christmas pudding, can more easily catch fire if overheated.
12. Never attempt to deep fry in the oven.
13. The appliance is not intended for use by young children or infirm persons without supervision.
14. Young children should be supervised to ensure that they do not play with the appliance

ELECTRICAL SUPPLY

WARNING
This appliance must be earthed. Failure to do so may result in electric shock and death.
The oven must be installed by a
qualified and approved electrician .
This equipment is not suitable for
connection to mains supply via a
standard 13amp plug
.
The installation wiring (hard wired or
socket fitting) must be in accordance
with current IEE regulations and safety
standards. The electrical supply lead
is located at the rear of the oven.
WARNING: A double isolating switch
must be fitted. This must have a 3mm
contact break on both poles.
If you are in any doubt about your
electrical supply, seek the advice of a
qualified and approved electrician.
It is essential that the electrical supply
is properly installed and earthed. It
should be fed from a cicuit which is
suitablefor very high power electrical
appliances and it is important that this
circuit is not overloaded.
Establishments with standard ( Type
'B' ) circuit breakers are sensitive to
'surges' which occur on switching on
freezers, refridgerators and other
catering equipment, including
microwave ovens. Because of this ,
we strongly recommend that a
separate Type 'C' circuit breaker
( designed specifically for this type
of equipment ) is fitted to each oven
installation.
SAVE THESE INSTRUCTIONS
BLUE
3
GREEN
&
BROWN
If fitted with a plug type connection
then the socket should be located in
an easily accessible position.