Programing Number Pads - Merrychef Mealstream serie Handbuch

PROGRAMMING NUMBER PADS ( 0-9 )
Pre-programming allows repetitive cooking procedures to be stored for ease
of use.
Each program can comprise up to three stages, allowing at each independent
control of Convection temperature, Stage time and Microwave power level.
However, programs must be used with caution since if the food to cook
varies in weight or density then good results and more importantly adequately
cooked food may not be achieved. Therefore, it is vital that all food prepared
for service should be checked to ensure that core temperatures have been
achieved.
1
Press and hold PROGRAM PAD until a flashing 'P'
appears in the PROGRAM DISPLAY
Lights on the TEMPERATURE
2
SETTING PADS flash to indicate
that a temperature must be
selected.
Press the pad for the required
temperature, the light on the
selected pad will continue to
flash, the others will go out.
3
Enter required cooking time by
pressing the TIME SET PADS
(The display colons flash to
indicate a time is required).
Only valid times of Minutes and
Seconds will be accepted.
e.g. 1 minute 1 second not 61 secs
To cook the food using a combination of
4
convected heat and microwave press
one of the POWER PADS
100%,75%,50% or 25%.
To cook using convection only press the
button marked with the fan symbol.
To save as a single stage program
Press the required number pad
example: stage 1 saved as Program 8
The program details are
displayed momentarily as the
program is saved.
To save as a multi-stage program
Follow steps 1– 4 for each stage
of cooking and on completing
press the PROGRAM PAD to
enter a second and third stage of
cooking to the program.
Press the required number pad to
save the program.
example: stage 1, stage 2, stage 3
saved as Program 8
12
An amount of experimentation
will be required to determine
the correct program for a
particular product.
Check program details on the
flashing display. Settings can
be changed by stepping back
through the program using the
CANCEL BUTTON.
• Enter a valid time up to
30 minutes e.g.
1 minute 1 second not
61 seconds.
• Information may be
programmed into the
memory whether the
oven is hot or cold.
• To review a program
use CALLBACK see
page 14.
We recommend you keep
a note of program
instructions for future
reference.