Exhaust Air Filter Maintenance; Extraordinary Maintenance; Replacing The Power Cable; Troubleshooting - Fimap FA15+ 2014 230V EU Bedienungs- Und Wartungsanleitung

2.

EXHAUST AIR FILTER MAINTENANCE

Carefully cleaning the exhaust air filter prolongs the life of the appliance. To clean the filter, proceed as follows:
1. Do what is required to make sure the appliance is in a safe condition (see
2. Turn the catches (1) of the filter compartment lid anti-clockwise.
3. Remove the filter compartment lid (2) from the appliance.
4. Take the exhaust air filter (3) out of the appliance.
WARNING: You are advised to always wear protective gloves, to avoid the risk of serious injury to your hands.
WARNING: The place this operation is carried out should comply with current environmental protection regulations.
5. Clean the filter with a jet of air from a distance of at least 20 cm. Replace it if damaged.
6. Repeat the operations in reverse order to reassemble all the parts.
1.

REPLACING THE POWER CABLE

To replace the power cable of the appliance, proceed as follows:
1. Do what is required to make sure the appliance is in a safe condition (see
2. Raise the vacuum tank (1) lid using the handle (2) on the front of the collection tank, turn the handle clockwise.
3. Using the handle (3), in the vacuum tank lid, remove the vacuum tank lid from the collection tank (rotating it and shifting it as indicated in the
figure). Put the vacuum tank lid gently on the floor.
4. Turn the power cable catch (4) 180 degrees anti-clockwise.
5. Remove the damaged cable.
6. Insert the new power cable plug (5) into the socket (6) on the appliance.
7. Turn the power cable catch (4) 180 degrees clockwise, and before doing this wind the cable inside its tear-proof housing (7).
1.

THE APPLIANCE DOES NOT SWITCH ON

1. Check that the main switch (1) is on, if not, press it.
2. Check that the plug (2) on the power cable (3) has been inserted into the mains socket (4).
3. Make sure that the electronic specifications of the appliance correspond to the specifications of the power supply network, check the technical
information on the serial number plate.
4. Check that the power cable is not damaged, and if it is replace it (read the section
WARNING: If all these procedures do not solve the problem, contact the technician at the specialist technical assistance centre.
WEEKLY MAINTENANCE
"APPLIANCE

EXTRAORDINARY MAINTENANCE

"APPLIANCE

TROUBLESHOOTING

Page 25
SAFETY").
SAFETY").
"REPLACING THE POWER CABLE").
EN