Locating The Components; Appliance Safety; Preparing To Work - Fimap FA15+ 2014 230V EU Bedienungs- Und Wartungsanleitung

4.

LOCATING THE COMPONENTS

The control panel components are identified as follows:
1. Vacuum nozzle.
2. Button for releasing the vacuum nozzle catch.
3. Collection tank lid release knob.
4. Slit for securing the extension hose.
5. Lifting handle.
6. Housing for winding the power cable.
7. Pin for fixing the lid of the collection tank.
8. Slot for fixing the lid of the collection tank.
9. Vacuum controller indicator light.
10. Main switch.
5.

APPLIANCE SAFETY

The stages for making the appliance safe, thereby making it possible to carry out operations safely, are as follows:
1. Make sure that the main switch (1) is in the rest position, if not, disable it.
2. Check that the plug (2) on the power cable (3) has been taken out of the socket (4) of the mains supply, and if not, disconnect it.
3. Wind the power cable under the appliance's lifting handle.
WARNING: you are advised to always wear protective gloves, to avoid the risk of serious injury to your hands.
ATTENTION: To prevent damaging the power cable, disconnect the plug from the mains socket by directly pulling the plug and not
the cable.
1.

PREPARING TO WORK

Before beginning to work, it is necessary to:
1. Before using, the appliance must be in order and safe to use with the work equipment, especially the power cable and the extension cable. If
everything is not in order, the appliance must not be used.
2. Do what is required to make sure the appliance is in a safe condition (see paragraph
3. Insert the vacuum hose (1) from the vacuum nozzle (2) on the collection tank, before pulling the vacuum hose press the button (3) for unlocking the
catch.
4. If not present in the appliance, insert a new filter - new collection bag (read the section
5. Select the most suitable accessory for the task at hand (see the chapter
ATTENTION: never use the appliance without the filters supplied with the machine (COLLECTION BAG-FILTER; AIR INTAKE
FILTER; EXHAUST AIR FILTER).
6. Insert the selected accessory into the vacuum hose.
7. If not present in the appliance connect the power cable (read the section
PREPARATION OF THE APPLIANCE
11. Accessories support.
12. Socket for electric brush.
13. Filter - disposable collection bag (optional).
14. Collection tank.
15. Collection tank lid.
16. Intake air cartridge filter.
17. Power cable.
18. Exhaust air filter.
19. Exhaust air filter compartment lid.
20. Power cable fastener.
21. Exhaust air filter compartment lid catch.
PREPARING TO WORK
"CHOOSING AND USING THE
"CONNECTING THE POWER
Page 21
"APPLIANCE SAFETY").
"INSERTING A FILTER - COLLECTION
ACCESSORY").
CABLE").
EN
BAG").