Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.
ELECTRIC BRUSH CONNECTION
If while you are working it is necessary to connect the appliance to an electric brush, proceed as follows:
1.
Switch off the appliance by pressing the main switch (1).
2.
Insert the power plug in the electric brush power cable into the socket (2) on the appliance.
3.
Switch on the appliance by pressing the main switch (1).
4.
Start working with the electric brush.
At the end of the work, and before carrying out any type of maintenance, carry out the following operations:
1.
Take the appliance to the place where it is maintained and carry out all the procedures listed in the chapter
2.
Take the appliance to the designated machine storage place.
3.
Do what is required to make sure the appliance is in a safe condition (see
4.
Insert the vacuum hose fastening clip in the support at the front of the handle in the collection tank lid.
WARNING: Park the appliance in an enclosed place, on a flat surface; near the appliance there must be no objects that could either
damage it, or be damaged through contact with it.
1.
REPLACING THE FILTER – COLLECTION BAG
To replace the filter - collection bag, proceed as follows:
1. Do what is required to make sure the appliance is in a safe condition (see
2. Raise the vacuum tank (1) lid using the handle (2) on the front of the collection tank, turn the handle clockwise.
3. Using the handle (3), in the vacuum tank lid, remove the vacuum tank lid from the collection tank (rotating it and shifting it as indicated in the
figure). Put the vacuum tank lid gently on the floor.
4. Remove the filter - collection bag from inside the collection tank being careful not to rip it. If the bag is made of paper, dispose of it properly, but if it
is made of fabric just empty it.
WARNING: You are advised to always wear protective gloves, to avoid the risk of serious injury to your hands.
WARNING: The place this operation is carried out should comply with current environmental protection regulations.
5. Do what is required to replace the filter - collection bag (see
WORK
AT THE END OF THE WORK
DAILY MAINTENANCE
PERFORM ALL MAINTENANCE OPERATIONS IN SEQUENCE
"INSERTING FILTER – COLLECTION
Page 23
"APPLIANCE
SAFETY").
"APPLIANCE
SAFETY").
BAG").
EN
"DAILY
MAINTENANCE".
Werbung
Kapitel
Inhaltsverzeichnis
