For Safe Use - Panasonic EYFPA1C Bedienungsanleitung

[Battery Pack]
EN EN
For Appropriate Use of Bat-
tery Pack
[Fig.20]
• The rechargeable batteries have a limited
life.
• For optimum battery life, store the Li-ion bat-
tery pack following use without charging it.
• When operating the battery pack, make sure
the work place is well ventilated.
Information for Users on Collection and Disposal of Old Equip­
ment and used Batteries
These symbols on the products, packaging, and/or accompanying documents mean
that used electrical and electronic products and batteries should not be mixed with
general household waste.
For proper treatment, recovery and recycling of old products and used batteries, please
take them to applicable collection points, in accordance with your national legislation
and the Directives 01/19/EC and 006/66/EC.
By disposing of these products and batteries correctly, you will help to save valuable
resources and prevent any potential negative effects on human health and the
environment which could otherwise arise from inappropriate waste handling.
For more information about collection and recycling of old products and batteries,
please contact your local municipality, your waste disposal service or the point of sale
where you purchased the items.
Penalties may be applicable for incorrect disposal of this waste, in accordance with
national legislation.
[For business users in the European Union]
If you wish to discard electrical and electronic equipment, please contact your dealer or
supplier for further information.
[Information on Disposal in other Countries outside the European
Union]
These symbols are only valid in the European Union. If you wish to discard these items,
please contact your local authorities or dealer and ask for the correct method of disposal.

For safe use

• The battery pack is designed to be installed
by proceeding two steps for safety. Make
sure the battery pack is installed properly to
the main unit before use.
• If the battery pack is not connected firm-
ly when the switch is switched on, the over-
heat warning lamp and the battery low warn-
ing lamp will flash to indicate that safe oper-
ation is not possible, and the main unit will
not rotate normally. Connect the battery
pack into the unit of the tool until the red or
yellow label disappears.
- 0 -