Setting Up And Aligning The Appliance; Attaching The Door Handle - hanseatic HKS18560DA2I Gebrauchsanleitung

Page GB-24 Start-up
– If you would like to reduce these distances,
you can fit an insulation plate between the
appliances.
– If underfloor heating is installed at the set-
up location, place the cooling appliance on
an insulation plate made from solid mate-
rial.
Setting up and aligning the
appliance
NOTICE
Risk of damage!
Insuffi cient air circulation may lead to
overheating and cause damage to the
appliance.
The entire space above the appliance
■
must remain clear.
The appliance should not stand di-
■
rectly against the wall (leave a mini-
mum clearance of 5 cm).
1. Place the appliance on as flat and as firm
a base as possible.
2. Check the position with a spirit level.
3. Level out any unevenness on the ground
using the two front screw feet (6).
– Close the door.
– Tilt the appliance backwards slightly and
screw/unscrew the screw feet (6).
– Stand the appliance back up again and
check the alignment with a spirit level.
Repeat the process until the appliance
is standing up vertically. The appliance
should not move when opening the door.

Attaching the door handle

If you wish, you can now attach the door han-
dle.
(16)
1. Use a knife or a flat-tip screwdriver to re-
move the blind plugs (16) from the side
of the door.
(17)
(6)
2. Secure the door handle (4) with the
screws provided (17).
(4)