Yamaha RX-V2065 Bedienungsanleitung Seite 71

Problem
No sound is output Output from that speaker is disabled.
from a specific
speaker.
The volume of that speaker is set to
minimum in "Speaker Setup" in the
"Setup" menu.
This unit is in the straight decode mode.
Sound may not be output from certain
channels depending on input sources or
sound field programs.
The speaker is malfunction.
No sound is heard
"LFE / Bass Out" is set to "Front" and a
from the subwoofer. Dolby Digital, DTS or AAC signals is
being played.
"LFE / Bass Out" is set to "Subwoofer" or
"Front" and a 2-channel source is being
played.
The source does not contain low
frequency signals.
No sound is heard "Extended Surround" in the Option menu
from the surround is set to "Off", or an input signal does not
back speakers.
contain a surround back flag with
"Extended Surround" set to "Auto".
The audio input
The connected component is not set to
sources cannot be output the desired digital audio signals.
played in the desired
digital audio signal
format.
Multi-channel The connected component is set to output
playback is not
2-ch or PCM signals.
available.
"Audio Output" is set to "Amplifier +
TV".
Cause
Check the Speaker indicators on the front panel
display. If the corresponding indicator is turned off,
try the following.
1) Change the input source to another one.
2) With the selected sound field program, sound is not
output from that speaker. Select another sound field
program.
3) "None" may have been selected for that speaker on
this unit. Display "Speaker Setup" in the "Setup"
menu and enables output of that speaker.
Display "Speaker Setup" in the "Setup" menu and
adjust the volume (Manual Setup → Speaker Level).
Press QSTRAIGHT (or rSTRAIGHT) to turn
off the straight decode mode.
Try another sound field program.
Check the speaker indicators on the front panel
display. If the corresponding indicator lights up,
connect another speaker and check if sound is output.
If sound is not output, this unit may be malfunction.
Set "LFE / Bass Out" to "Subwoofer" or "Both".
Set "LFE / Bass Out" to "Both".
Set "Extended Surround" other than "Off" or "Auto".
Set the playback component properly referring to its
operating instructions.
Set the playback component properly referring to its
operating instructions.
Set "Audio Output" to "Amplifier".
Troubleshooting
Remedy
See
page
6, 24, 27,
48
50
30
27
—
49
49
43
—
—
51
67
En