Dsp Parameter - Yamaha RX-V2065 Bedienungsanleitung

Operating various settings for this unit (Setup menu)
On Permit access to this unit only from network
devices with the specified MAC addresses.
MAC Address 1-10
Specify MAC addresses of network devices that are
permitted to access to this unit when "MAC Address
Filter" is set to "On".
■
Network Standby
Choices:
Off*, On
Selects whether or not to accept the commands via
network when this unit is on standby.
Off Not accept the commands via network.
On Accept the commands via network.
y
• When "Network Standby" is set to "On", the amount of power
consumption in the standby mode increases.
■
Information
Displays the network parameters (IP address, etc.) or
vTuner ID assigned to this unit.
54
En

DSP Parameter

Although the field sound programs would satisfy you as
they are with the default parameters, you can arrange
sound effect or decoders suitable for acoustical conditions
of sources or rooms by setting the parameters.
1
Press jCursor k / n to select "DSP
Parameter" and then press jENTER.
Sound field program
DSP Parameter
Program Name
Decode Type
DSP Level
P. Initial Delay
P. Room Size
Sur. Initial Delay
Sur. Room Size
Sound field parameters
2
Press jCursor k / n to select "Program
Name" and then press jCursor l / h to
select a sound field program to edit.
3
Press jCursor k / n to select a parameter to
edit and then press jCursor l / h to
change the setting.
y
• Repeat steps 2 and 3 to change other sound field program
parameters.
To initialize the parameters of the selected sound field
program, press jCursor n repeatedly to select
"Initialize" and then press jCursor h. Then, press
jCursor h again to execute the initialization or
jCursor l to cancel it.
CINEMA DSP basic parameters
DSP Level
Adjustable range: –6dB to 0dB* to +3dB
Fine adjusts an effect level (level of the sound field effect
to be added). You can adjust the level of the sound field
effect while checking sound levels. Adjust "DSP Level" as
follows.
• The effect sound is too soft.
• There are no differences between effects of the sound
field programs.
→Increase the effect level.
• The sound is dull.
• The sound field effect is added too much.
→Reduce the effect level.
Sci-Fi
PLIIx Movie
0dB
16ms
1.0
2ms
1.0
Set values