Safety Rules; General; Proper Use; Environmental Conditions - Fronius VR 1500-PAP Bedienungsanleitung & Ersatzteilliste

Safety rules

General

The device is manufactured using state-of-the-art technology and according to recognised
safety standards. If used incorrectly or misused, however, it can cause:
-
-
-
All persons involved in commissioning, operating, maintaining and servicing the device
must:
-
-
-
The operating instructions must always be at hand wherever the device is being used. In
addition to the operating instructions, attention must also be paid to any generally applica-
ble and local regulations regarding accident prevention and environmental protection.
All safety and danger notices on the device
-
-
-
-
For the location of the safety and danger notices on the device, refer to the section headed
"General" in the operating instructions for the device.
Before switching on the device, rectify any faults that could compromise safety.
This is for your personal safety!

Proper use

The device is to be used exclusively for its intended purpose.
The device is intended solely for the welding processes specified on the rating plate.
Any use above and beyond this purpose is deemed improper. The manufacturer shall not
be held liable for any damage arising from such usage.
Proper use includes:
-
-
-
Never use the device for the following purposes:
-
-
-
The device is designed for use in industry and the workshop. The manufacturer accepts
no responsibility for any damage caused through use in a domestic setting.
The manufacturer likewise accepts no liability for inadequate or incorrect results.
Environmental Operation or storage of the device outside the stipulated area will be deemed as not in ac-
conditions cordance with the intended purpose. The manufacturer shall not be held liable for any dam-
age arising from such usage.
injury or death to the operator or a third party,
damage to the device and other material assets belonging to the operating company,
inefficient operation of the device.
be suitably qualified,
have sufficient knowledge of welding and
read and follow these operating instructions carefully.
must be in a legible state,
must not be damaged,
must not be removed,
must not be covered, pasted or painted over.
carefully reading and following all the instructions given in the operating instructions
studying and obeying all safety and danger notices carefully
performing all stipulated inspection and maintenance work.
Thawing out pipes
Charging batteries
Starting engines
35