Troubleshooting - IKEA TVÄTTAD PNC914580227 Bedienungsanleitung

ENGLISH
Warning! Make sure that the
temperature is higher than 0 °C
before you use the appliance
again.
The manufacturer is not
responsible for damages caused
by low temperatures.

Troubleshooting

Warning! Refer to Safety
chapters.
Introduction
The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the table). If the problem persists, contact
the Authorised Service Centre.
Warning! Deactivate the appliance before carrying out any check.
In case of major problems, the acoustic signals operate, the display shows an alarm
code and the Start/Pause
• - The mains supply is unstable. Wait until the mains supply is stable.
• - No communication between electronic elements of the appliance. Switch it off
and switch on again. The programme was not finished properly or the appliance
stopped too early. If the alarm code appears again, contact the Authorised Service
Centre.
• - The appliance does not fill with water properly. After the proper check, start the
appliance again by pressing Start/Pause
cycle . If the error persists the alarm code will appear again.
• - The appliance does not drain the water.
• - The appliance door is open or not closed correctly. Please check the door!
If the appliance is overloaded, remove some items from the drum and/or hold
the door shut while touching the Start/Pause
stops flashing (see the picture below).
button may flash continuously:
button the appliance tries to resume the
button until the indicator
29