IKEA TVÄTTAD PNC914580227 Bedienungsanleitung Seite 28

ENGLISH
When you drain the water with the
emergency drain procedure, you must
activate the drain system again:
1. Put 2 litres of water in the main wash
compartment of the detergent dispenser
drawer.
2. Start the programme to drain the water.
Cleaning the inlet filter and the filter valve
If the appliance takes long to fill with water
or doesn't fill, the starting button indicator
flashes in red. Check if the water inlet filter
and the valve filter are blocked (see
chapter "Troubleshooting" for more details).
Proceed as follows:
• Unscrew the hose from the appliance.
Keep a rag nearby because some water
may flow.
• Clean the filter in the valve with a stiff
brush or with the piece of cloth.
• Turn off the water
tap.
• Unscrew the hose
from the tap.
• Clean the filter in
the hose with a stiff
brush.
• Screw firmly the
inlet hose back
onto the tap.
35° 45°
• Turn on the water tap.
Emergency drain
If the appliance cannot drain the water,
carry out the same procedure, described in
'Cleaning the drain pump' paragraph. If
necessary, clean the pump.
When you drain the water with the
emergency drain procedure, you must
activate the drain system again:
1. Put 2 litres of water in the main wash
compartment of the detergent dispenser
drawer.
2. Start the programme to drain the water.
Frost precautions
If the appliance is installed in an area
where the temperature can reach values
around 0° C or drop below, remove the
remaining water from the inlet hose and the
drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in a
container and let the water flow out of
the hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty, install
the inlet hose again.
28
• Screw the hose
back to the
appliance turning
it to the left or the
right to suit the
installation. Tight
the locknut
correctly to
prevent water
leaks.