General Power Tool Safety Warnings; Work Area Safety - Parkside PABS 20-Li D5 Originalbetriebsanleitung

High-speed battery charger: PLG 20 A1
INPUT
Rated voltage
Rated power
consumption
Fuse (internal)
OUTPUT
Rated voltage
Rated current
Charging time
Protection class
Noise emission value
Noise measurement value determined in accord-
ance with EN 62841. The A-rated noise level of
the power tool is typically:
Sound pressure level: L
Uncertainty K:
Sound power level:
Uncertainty K:
Vibration emission value
Total vibration values (vector total of three direc-
tions) determined in accordance with EN 62841:
Screwdriving: Vibration emission value
a
Uncertainty K = 1.5 m/s
Drilling in metal: Vibration emission value
a
Uncertainty K = 1.5 m/s
NOTE
► The vibration emission values and the noise
emission values specified in these instructions
have been measured in accordance with a
standardised test procedure and can be used
for comparing the power tool with another
power tool
► The specified total vibration values and the
noise emission values can also be used to
make a provisional estimate of the load.
PABS 20-Li D5
230–240 V ∼, 50 Hz
(AC)
65 W
T3.15A
3.15 A
21.5 V (DC)
2.4 A
approx. 60 min.
II / (double insulation)
= 68.5 dB (A)
pA
K = 3 dB
PA
L = 79.5 dB (A)
WA
K = 3 dB
WA
2
: 0.601 m/s
h
: 1.070 m/s 2
h,D
WARNING!
► Depending on the manner in which the power
tool is being used, and in particular the kind
of workpiece being worked, the vibration and
noise emission values can deviate from the
values specified in these instructions during
actual use of the power tool.
► Try to keep the vibration load as low as possible.
Measures to reduce the vibration load are, e.g.
wearing gloves and limiting the working time.
Wherein all states of operation must be includ-
ed (e.g. times when the power tool is switched
off and times where the power tool is switched
on but running without load).
General power tool
safety warnings
WARNING!
►
Read all safety warnings, instructions,
illustrations and specifications provided
with this power tool. Failure to follow all
instructions listed below may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
2
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool.
2

1. Work area safety

a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b) Do not operate power tools in explosive atmos-
pheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can
cause you to lose control.
GB │ MT │
31 ■