Anti-Blocking Switch (Abs); Trimming Function - UNITED OFFICE ULG 300 A1 Bedienungsanleitung

³
The finished laminated pocket is now ejected
a
from the foil slot
Only after hot lamination:
³
Remove them immediately from the appliance,
as hot foil pockets can still be easily deformed.
Place them on a flat surface to cool down.
To improve the lamination result, you can
weigh down the still hot foil bag with a
book, a file folder or other heavy, smooth
object. This will give it a smooth and flaw-
less surface.
³
If you do not want to start another lamination
process, turn the foil thickness switch
(OFF) and withdraw the plug from the mains
power socket.

Anti-Blocking Switch (ABS)

At the start of the lamination process, the pouch
may be pulled in at an angle or jam itself inside the
appliance.
³
Turn the anti-blocking switch (ABS)
position ABS.
• The laminate pouch is not pulled any further in.
³
Remove the laminate pouch.
³
Turn the anti-blocking switch (ABS)
the desired foil thickness.
³
Re-start the lamination process.
of the laminator.
o
to ABS
o
to the
o
back to

Trimming function

Should you wish to use the trimming function on the
q
foil guide rails , dismantle the foil guide rails
³
If necessary, fold the documents support
down.
³
Adjust the cutter attachment
a straight face with the foil guide rails
³
Slide the cutting head
e
cutting head
w
cutting rail
³
Flap the cutting rail
ded grip and position the document on the foil
q
guide rails
the foil format restraint
touch both sides of the document.
³
Use the markings on the measurement table to
align the document precisely.
³
Flap the cutting rail
engages.
³
Hold the paper in a secure position with your
left hand.
³
To trim, press the cutting head
the right hand and then slide it with one pull or
push over the document.
- 7 -
d
so that it forms
e
to the end stop (the
can be slid to both ends of the
).
w
upwards with the roun-
. Restrain the document by sliding
r
together until they
w
downwards so that it
e
down with
q
.
s
q
.