Anti-Blocking Switch (Abs); Trimming Function; Cleaning And Care - UNITED OFFICE ULG 300 A1 Bedienungsanleitung

➩
If you do not want to start another lamination
process, turn the foil thickness switch
(OFF) and withdraw the plug from the mains
power socket.

11. Anti-Blocking Switch (ABS)

At the start of the lamination process, the pouch
may be pulled in at an angle or jam itself inside the
appliance.
➩
Turn the anti-blocking switch (ABS)
position ABS.
• The laminate pouch is not pulled any further in.
➩
Remove the laminate pouch.
➩
Turn the anti-blocking switch (ABS)
the desired foil thickness.
➩
Re-start the lamination process.

12. Trimming function

Should you wish to use the trimming function on the
pouch guide , dismantle the pouch guide
q
➩
If necessary, fold the documents supports
down.
➩
Adjust the cutter attachment
a straight face with the foil guide rails
➩
Slide the cutting head
cutting head can be slid to both ends of the
e
cutting rail w ).
➩
Flap the cutting rail
w
grip and position the document on the pouch
guide q . Restrain the document by sliding the
pouch format locks
both sides of the document.
➩
Use the markings on the measurement table to
align the document precisely.
➩
Flap the cutting rail
engages.
All manuals and user guides at all-guides.com
to ABS
o
to the
o
back to
o
.
q
s
so that it forms
d
.
q
e to the end stop (the
upwards with the rounded
together until they touch
r
downwards so that it
w
➩
Hold the paper in a secure position with your
left hand.
➩
To trim, press the cutting head
the right hand and then slide it with one pull or
push over the document.

13.Cleaning and care

Potentially fatal electrical shock:
• Never open the appliance housing. There
are no user-serviceable elements inside.
• Never submerse the appliance into water
or other liquids!
Cleaning the housing:
Clean the surface of the housing with a
slightly moistened cleaning cloth.
➩
First remove the plug.
➩
Allow the appliance to cool down completely.
➩
Ensure that no moisture can permeate into the
appliance.
Cleaning the interior of the appliance:
With every lamination, contaminants are deposited
on the rollers inside the laminator. Over time, this re-
duces the performance of the laminator. You should
therefore clean the rollers inside the laminator after
use.
➩
Prepare the appliance as described in Chapter
8 "Preparing for hot lamination", up to the point
where the green indicator lamp "Ready"
y glows.
- 7 -
e down with