Kenwood CH257 Bedienungsanleitungen Seite 4

before plugging in
Make sure your electricity supply is
G
the same as the one shown on the
underside of the appliance.
This appliance conforms to EC
G
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
before using for the first
time
Wash the parts: see 'cleaning'.
key
1
bowl
2
cord storage
3
power unit
4
'safety' interlock
5
spatula
6
lid
7
speed selector
8
oil feeder cup
9
upper knife blade
bk
lower knife blade
to use your food
chopper
The knife blade unit comes in 2
parts, a lower and an upper blade.
For coarser chopping use the
G
lower blade on its own.
For finer chopping or pureeing use
G
both blades together. This will also
give a faster result. To use both
blades fit the upper blade onto the
lower blade and turn anti-
clockwise to locate in place
Take care as the blades are sharp.
Note: After processing food, the
upper blade may disengage from
the lower blade. This is normal as
the blade assembly is designed to
be loose fitting to ease separation
after use.
1
1 Fit the bowl
unit, then turn clockwise to lock
3
into place .
2 Fit the blade assembly into the
bowl.
2
.
onto the power
Always fit the bowl and blade
G
assembly onto the food chopper
before adding ingredients.
3 Cut the food into suitably sized
pieces and place in the bowl.
Larger pieces of food should be
cut into approximately 1 to 2 cm
pieces.
4 Fit the lid and turn clockwise to
lock into place
5 Connect to the power supply and
press down on the speed selector
to select the desired speed
Press the speed selector lightly to
G
obtain speed 1.
Press the speed selector firmly to
G
obtain speed 2.
Alternatively the speed selector
G
may be pressed down for short
periods of time to produce a
pulsing action. This can be used to
avoid over processing food.
6 Operate the food chopper until the
desired result is achieved.
7 Reverse the above procedure to
dismantle the unit.
Always unplug the power
G
unit before removing the lid.
important
If preparing food for babies or
G
young children, always check that
the ingredients are thoroughly
blended before feeding.
Do not run the food chopper
G
continuously for longer than
60 seconds. Leave to cool
for 2 minutes in between
each 60 second operation.
Do not operate the food chopper if
G
the bowl is empty.
Always allow hot food to cool
G
before processing.
Do not exceed the maximum
G
capacities stated or fill above the
500ml level marked on the bowl.
Do not place any part of the
G
chopper in the microwave.
hints
If the chopper labours, remove
G
some of the mixture and continue
processing in several batches,
otherwise you may strain the
motor.
4
4
.
5
.