Philips ZOOM! Bedienungsanleitung Seite 17

22 Carefully remove the whitening gel with the
surgical suction tip and/or wipe the surface
of enamel clean with damp gauze. Do not
irrigate as the force of the water may pull the
dam loose and saturate isolation materials.
23 Check the isolation materials to make sure
'no pink' tissue is visible. Replace or add
isolation if needed.
24 Follow the same instructions as above for
the remaining sessions.
25 When all sessions on a light guide are
finished, the display reads 'Sessions
Complete' for three seconds, followed by
'Guide Status – Replace Guide. Detach the
light guide from the IsoPrep retractor and
pull the LED Accelerator away from the
patient.
Note: For sensitive patients, lower the
intensity of the LED Accelerator. However,
please note this could result in a fourth
15-minute session.
Tip: If the patient notes tooth sensitivity,
place Relief ACP (found in the procedure kit
or in the patient's Post Care & Maintenance
kit) on the lingual surface(s) for the remaining
sessions. After the last session is complete,
detach the light guide from the retractor
and pull the LED Accelerator away from the
patient. Suction or wipe the whitening gel
from the teeth. Moisten gauze and cotton
rolls and remove the isolation materials.
If barrier material remains interproximally,
remove it with floss.
26 Reinsert the retractor and take a retracted
'after' photo with the lighter shade tab
in place. Measure the shade change by
counting the shade shift according to the
value-ordered shade guide.
English
17