Philips ZOOM! Bedienungsanleitung Seite 16

English
16
18 Slide the LED Accelerator into place next to
the patient. The arm of the LED accelerator
should be movable, but stable. Position the
LED Accelerator head by aligning the slots
on the light guide with the retractor.
19 Follow the prompts on the display panel to
switch on the light and to activate the timer.
Once the light is on, a countdown is
displayed. Light emits from where the arrow
points. Light emits from the LED accelerator
head to shine on the patient's teeth.
It is normal for the light to flicker for the first
few seconds.
The LED Accelerator beeps once when three
minutes of the session are remaining and
beeps three times in the final three seconds
of the 15-minute session.
When the session is finished, the light goes
out and you hear a long beep.
Note: If a session must be interrupted, press
the 'Pause' button. The remaining session
time flashes on the display. To reactivate
the session, press either the 'Pause' or 'Start'
button.
20 Inform the patient that the progress of each
session are tracked by four white lights on
top of the LED Accelerator head. Each light
indicates one quarter of a session.
Note: During each 15-minute session,
make sure the patient has a means of
communication (e.g. a bell) or do not leave
the patient unattended.
21 After each session, gently pull the LED
Accelerator away from the patient, taking
care not to dislodge isolation materials.
Note: At the end of each 15-minute session,
the display indicates the number of remaining
sessions left on the light guide. Press ‚Start' to
activate the light for the next session.