Memory Function; Error Code - NSK ULTIMATE XL-K Bedienungsanleitung

7. Memory Function

When the 12 Power Switch is turned on, the rotation direction made when the switch was last
turned off are restored. Special attention should be given to the rotation direction.

8. Error Code

When the motor is stopped due to some trouble such as a failure, overload, wire breakage or
misuse, Speed Display displays the error code for checking the status of the unit and
understanding the cause of the trouble easily.
Error cord
E0 Self-check error
Overcurrent detection error
E1
(Hard)
E2 Overvoltage detection error
E3 Motor sensor error
E4 Unit overheat error
E5 PAM circuit error
E6 Rotor lock error
Overvoltage detection error
E8
(Soft)
E9 ITRIP error
EF Foot pedal error
For countermeasures against error displays, see the section on 15.Troubleshooting.
Description
9
Cause
• Abnormal internal memory
• Broken internal memory
• Long-time use at a high load (overcorrect)
• Shorted cord (power line)
• Shorted motor winding
• Failure of a turbine adapter
• Shorted cord (power line), damaged circuit
• Broken internal circuit
• Failure of a turbine adapter
• Faulty sensor (Hall IC) in the motor
• Disconnected motor cord
• Severed cord (signal line)
• Open chuck
• Faulty handpiece
• If the cord of the turbine adapter is loosed.
• Temperature rise in the unit due to longtime
use at a high load
• Unit placed under high temperature
• Abnormal voltage generated in start / stop
circuit
• Faulty start / stop circuit from PAM (L Slide)
• Open chuck
• Faulty handpiece
• Motor Faulty
• Faulty sensor (Hall IC) in the motor
• Severed cord (signal, power line)
• Long-time use at a high load (overcorrect)
• Shorted cord (power line)
• Shortstop of the motor winding
• Failure of a turbine adapter
Faulty motor and circuit
• Faulty Foot Pedal or Shorted Foot Pedal cord
• Broken internal circuit