Herunterladen Inhalt Inhalt Diese Seite drucken

Installation Tips; Installation; Installing Method For Group Ii (15-25 Kg)/ Iii (22-36 Kg) - be cool thunder iso-fix Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 30
NEVER UNDER ANY CIRCUMSTANCE should you
carry your baby in your arms in the car, or out of
the car seat. Although it may seem strange, in case
of an accident, even at only 40 km/hr the force is
such that it would be completely impossible to hold
onto your baby.

INSTALLATION TIPS

1) The THUNDER ISO-FIX shall be used with isofix anchors plus
top tether for group I (9- 18kg child).
2) The THUNDER ISO-FIX must be used with ISOFIX anchors (no
top tether needed) at the same time that with a 3-point seat
belt for group 2, 3 (15-36kg child).
3) The THUNDER ISO-FIX must be fitted as a forward-facing
position in the rear seats of vehicle.
Four positions of the car seat.
The THUNDER can be used in four different positions. (Fig. 1):
Pull the positioning handle under the front of the seat forwards or
backwards (feel the spring underneath), then release the handle
on your required position while hearing a distinct click.
ISO-FIX G. I

INSTALLATION

Installing method for Group I (9-18 kg)
a) Place the THUNDER ISO-FIX on the vehicle's seat.
IM-1613,04 THUNDER ISOFIX inst OK.indd 19
b) Rotate the adjuster button in anti-clock wise direction (F2-A)
and pull the isofix anchors out-wards as far as it goes, make
sure it can't be pushed back (F2-B).
c) Push the car seat towards the back of vehicle's anchoring point
(F3-A) and match theisofix anchors to the vehicle's anchoring
point until hear a "click" (F3-B).
e) Rotate the adjuster button in anti-clock wise direction (F4-A)
and push the car seat to the back of vehicle's seat as much as
possible (F4-B).
f) Hook the top tether up and pull as tight as possible (F7).
ISO-FIX G. II-III
INSTALLING METHOD FOR GROUP II (15-25 KG) /
III (22-36 KG)
The installation method is for child within Group II (15-25 kg) and
Group III (22-36 kg).
a) Remove the harness system, including the belt pads, central
buckle and crotch strap.
b) Adjust the headrest by pulling the lifting handle at your requi
red position according to your child's height.
c) Place your child into the car seat.
d) Thread the vehicle's shoulder belt from the Group II belt guide
slot (Fig. 14-a), or Group III belt guide slot (Fig. 14-b), and thread
the lap belt through the belt guide (Fig. 14-c).
So the installation is completed (Fig. 14-d).
e) Joint the belts and buckle up.
EN
19
20/6/18 10:51

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis