Maintenance & Cleaning General; Changing The Cover; Checklist - be cool thunder iso-fix Bedienungsanleitung

shoulder straps back through the shoulder pads, cover and
shell. (Fig. 18)
i) Connect the shoulder belts to the belt yoke. (Fig. 19-a)
MAINTENANCE & CLEANING GENERAL
a) The car seat can be cleaned by using lukewarm water and
soap. Do not use aggressive cleaners like abrasives or
thinner.
b) The cover should be washed by hand at a maximum
temperature of 30ºC. Do not put it in the dryer.
c) It is advised to buy an extra cover when purchasing the car seat
that you can continue using it when one cover is being washed.
Step 1: Take the car seat out of your car; ensure your entire baby's
car toys are put away before you begin cleaning it.
Step 2. Suck up food particles and dirt with a cordless vacuum. If
possible, use a portable vacuum cleaner's furniture attachment to
clean the small, hard-to-reach areas of the car seat.
Step 3. Clean off the plastic portions of the seat with gentle soap
and water.
Step 4. Remove the entire car seat cover, if possible, and run it
through your washing machine gentle cycle.
Stpe 5. Spot clean the stained spots on the car seat if you cannot
remove the cover; make sure you can use the soap on the car
seat's material by checking the package's guidelines.
Step 6. Reinstall the clean car seat in your car, and take special
care that all parts of the car seat being present and installed safely
IM-1613,04 THUNDER ISOFIX inst OK.indd 21
and correctly.

CHANGING THE COVER

Removing and Replacing the cover and belt pads
a) Loosen the belts pads. (See adjusting the height of the shoulder
belts)
b) Loosen the cover all around. (Fig. 20)
c) Pull the belts, buckle tongues and buckle through the cover.
d) Remove the cover.
e) After washing, attach the belt pads and place the cover on the
shell.
f) Thread the buckle, tongues and belts through the cover and
fasten the cover at the release button/positioning handle.
g) Secure the cover on the pins.
h) Close the buckle and thread the belts through the belt pads,
cover and shell.
i) Connect the shoulder belts to the belt yoke.
j) Fasten the cover all around, behind the pins.

CHECKLIST

For safety's sake read through this checklist before you set off.
Check that the harness belt system fits properly and tightly
around your child and that the shoulder belts are at the correct
height.
EN
21
20/6/18 10:51