Charging The Rechargeable Battery; Maintenance And Care; Troubleshooting - LIVARNO LUX HG00510 Bedienungs- Und Sicherheitshinweise

4. Exchange the old rechargeable battery
Take care to the correct polarity, when inserting the new
rechargeable battery. The polarity is indicated in the bat-
tery compartment. The new rechargeable battery has to
have the same technical data like the old one.
5. Now again fasten the battery compartment lid
the fastening screws
driver. Slide the On / Off switch
6. Connect the solar cell housing
shade and then connect every part of the product to
2
each other (see Fig. C).

Charging the rechargeable battery

Note that the product must be switched on when the battery
is charging.
The charging time of the battery when the solar cell is used
depends on the intensity of the sunlight and the angle of
incidence of the light on the solar cell. Place the solar cell as
perpendicular as possible to the angle of incidence of the
light. In this way you will receive the highest light levels.

Maintenance and care

The light-emitting diodes cannot be replaced. The product is
maintenance-free, except for any necessary change of battery.
Clean the product regularly with a dry, lint-free cloth. Use a
slightly dampened cloth to remove more stubborn dirt.

Troubleshooting

Note: This product has delicate electronic components. This
means that if it is placed near an object that transmits radio
signals, it could cause interference. If you notice that the product
is malfunctioning, remove any sources of interference from the
area of the product.
Note: Electrostatic discharges may cause product to malfunction.
In the event of such malfunctions, remove the batteries briefly
and reinsert them.
by using a small cross head screw-
6
to the position ON.
5
again to the lamp
1
to a new one.
8
, fasten
7
GB/CY 11