Preparing For Use; Installing The Product; Setting Up The Product; Replacing The Rechargeable Battery - LIVARNO LUX HG00510 Bedienungs- Und Sicherheitshinweise

Preparing for use

Installing the product

Install the product in accordance with Figures A, C, D:
1. Rotate the solar cell housing
lamp shade
2. Move the ON / OFF switch
switch the light on.
3. Insert the solar cell housing
tighten by turning it clockwise.
4. Place the light on to the pole
5. Take out the ground stake
it into the pole
Fig. C).
6. Your product is ready for use (see Fig. D).

Setting up the product

Insert the assembled product far enough into the ground
(lawn, flower bed) for it to be stable.
Make sure you keep proper footing and balance at all
times. Do not use any force when assembling or setting-up
the product, e.g. hammer blows. This will damage the
product. In order to achieve the best result, set the product
up in a place where the solar cell will get direct sunlight
for as long as possible.
Make sure that the solar cell is not influenced by any
other source of light such as yard or street lighting as
otherwise the light will not come on in twilight.
The light automatically switches on in twilight conditions
and off again when normal outdoor lighting conditions
return.

Replacing the rechargeable battery

The battery should be replaced every 12 months to ensure
optimum performance.
1. Separate the solar cell housing
by moving it anti-clockwise (see Fig. A). Switch off the
2
light with the ON- / OFF-switch
2. Loosen the fastening screws
head screwdriver and then lever out the battery compart-
ment lid
slot screwdriver (see Fig. B).
3. Turn over the battery compartment lid
damage the cables and cable connections (see Fig. B).
10 GB/CY
(see Fig. A).
2
with the tip facing downwards (see
3
of the solar cell housing
7
anticlockwise out of the
1
into the ON position to
5
into the lamp shade
1
.
3
from the pole
4
from the lamp shade
1
.
5
by using a small cross
6
with the help of a
1
, take care not to
7
and
2
and insert
3