Preparing For Use; Installing The Product - LIVARNO LUX 313247_1904 Montage-, Bedienungs- Und Sicherheitshinweise

Slide the ON / OFF switch
The rechargeable battery
cell depends on the intensity of the sunlight and the angle
2
incidence of the light on the solar cell
as perpendicular as possible to the angle of incidence of the
light. In this way you will receive the highest light levels. Replace
the rechargeable battery
after charging (see "Replacing the rechargeable battery").

Preparing for use

Note: The solar cell
motion sensor
3
The "ON" position for the ON / OFF switch
the following functions:
If the orientation light is constantly lit up, it will automatically switch
on or off once the solar cell
long operating life, the LEDs will not be fully powered in this setting.
If the rechargeable battery is fully charged, the charge will be suffi-
cient for approx. 8 hours of lighting (see Fig. G). As soon as the mo-
tion sensor detects movement, the product will switch to
3
particularly bright light (see Fig. H). While the particularly bright
light is switched on, the LEDs will be run at full power. Approx. 40
seconds after the last movement has been detected, the product
will return to functioning as a constantly lit-up orientation light.

Installing the product

Install the product in accordance with Figures A, E:
1. Rotate the solar cell housing
shade (see Fig. A).
5
2. Move the ON / OFF switch
the product switching on during darkness.
1
9
if the light output does not improve
9
also works as a twilight sensor, while the
2
only responds to movement.
detects dusk or dawn. To ensure a
2
4
1
to the "ON" position.
charging period using the solar
. Place the solar cell
2
anticlockwise out of the lamp
into the "ON" position to enable
2
features
1
GB/IE 25