Technical Data - Leuze BPS 8 S M 100-xx Anleitung

Decommissioning, maintenance
CAUTION
 Do not open the device yourself under any circumstances! There is otherwise
a risk of uncontrolled emission of laser radiation from the device. The housing
of the BPS 8 does not contain any parts that need to be adjusted or serviced
by the user. If faults cannot be cleared, the device should be switched off and
protected against accidental use.
 Package the device for transport and storage in such a way that is protected
against shock and humidity. Optimum protection is achieved when using the
original packaging. Ensure compliance with the approved environmental con-
ditions listed in the specifications.
 Do not use aggressive cleaning agents such as thinner or acetone for clean-
ing the device.

Technical data

NOTE
Technical data
 Additional specifications and notices for using the device can be found in the
operating instructions.
1)
Operating voltage
Power consumption
Light source
Laser class
Wavelength
Impulse duration
Max. output power (peak)
Measurement range
Reproducible accuracy
Output time
Response time
Basis for contouring error calculation
Polling interval
Traverse rate
Beam exit
Reading distance/working range
4.9 ... 5.4VDC acc. to IEC 742
(10 ... 30VDC in combination with
MA 8-0X, optional)
Max. 1.5W
Laser
2 (in accordance with IEC 60825-
1:2007), see
1
655nm
< 420μs
1.7mW
0 ... 10,000,000 mm
± 1 (2)mm
3.3ms
26.6ms (configurable)
13.3ms
 10ms
Max. 4m/s
On front or lateral with deflecting mirror
See
4
EN
23