Displays - Silvercrest SLE 450 A1 Bedienungsanleitung

__CPE111670_B1.book Seite 54 Mittwoch, 11. März 2015 12:49 12
• The device switches off when the water
tank is full or has been removed.
Air outlet flap valve
• Figure A: irrespective of which mode
the device is being operated in, open
the top flap valve 1. It's infinitely adjust-
able. If the flap valve is not opened, the
overheating protection will switch the
device off after a while for approx.
3|minutes.

7.2 Displays

The mode of operation LEDs 16 and the dis-
play 15 show the selected functions and the
humidity range.
Mode of operation LEDs
LED illuminated
The water tank is
WASSERTANK VOLL
full or has not been
(TANK FULL)
inserted.
A switch-off time is
TIMER AKTIV
activated.
LUFTREINIGUNG
(AIR CLEAN)
WÄSCHETROCK-
NUNG
(DRY CLOTHES) Selected mode
ZIEL-LUFTFEUCHTIG-
KEIT (TARGET HUMI-
DITY)
AUTOMATIK
BETRIEB The device is
(OPERATION) switched on.
54 GB
Display
Display
LC
Meaning
1 - 24
flash for 5 sec.
30 - 80 or CO
flash for 5 sec.
Meaning
This display can be seen
continuously during oper-
ation. It shows the humid-
ity range in the room:
HOCH
MITTEL
NIEDRIG (LOW):
NIEDRIG
under 65%
MITTEL (MID):
HOCH
MITTEL
65% to 75%
NIEDRIG
HOCH (HIGH):
over 75%
HOCH
MITTEL
NOTE: this display is not
NIEDRIG
visible if the child safety
lock is activated.
The child safety lock is
activated. The device
cannot be operated by
using the buttons.
Timer for all modes:
These values (1 - 24 hours)
will flash for 5 seconds
when you use the arrow
keys to select a switch-off
time.
Enter relative humidity as
target humidity.
Values between 30 and
80 or CO will flash for
5|seconds when
selected.
CO: The device dehu-
midifies continuously.