Maxwell MW-3021 VT Die Betriebsanweisung Seite 10

ENGLISH
• When the soleplate temperature (14) reaches
the desired temperature value, the pilot lamp
(6) will go out, you can start ironing.
Note:
– While steam ironing set the necessary steam
generation rate using the steam supply knob
(4).
Dry ironing
• Place the iron on its base (9).
• Insert the plug into the socket.
• Turn the temperature control knob (11) to set
the required ironing temperature: "•", "••",
"•••" or max, (depending on the fabric type),
set the constant steam supply knob (4) to the
"0" position, the pilot lamp (6) will light up.
• When the soleplate temperature (14) reaches
the desired temperature, the pilot lamp (6)
will go out, you can start ironing.
• After you finish ironing set the temperature
control knob to the "MIN" position.
• Pull the plug out of the socket and let the iron
cool down completely.
Steam ironing
The iron has an anti-drip valve, that stops water
supply, when the soleplate temperature is too
low, it prevents dripping from the soleplate
openings (14). During heating and cooling of the
iron soleplate you will hear corresponding clicks
of anti-drip valve opening/closing, that indicates
its normal operation.
• Place the iron on its base (9).
• Insert the plug into the socket.
• Make sure that there is enough water in the
water tank (13).
• Turn the temperature control knob (11) to
set the required ironing temperature: in the
steam operation zone or «MAX» (•••), the
pilot lamp (6) will light up.
• When the soleplate temperature (14) reaches
the desired temperature, the pilot lamp (6)
will go out, you can start ironing.
• Turn the constant steam supply knob (4) to
set the steam generation rate, steam will start
outgoing from the soleplate (14) openings.
• Set the temperature control knob (11) to the
"MIN" position, and the constant steam sup-
ply knob (4) to the "0" position.
MW-3021.indd 10
• Pull the plug out of the socket and let the iron
cool down completely.
Attention!
If steam is supplied not constantly during the
operation, check the correct position of steam
supply knob (4) and water level in the water tank.
Additional steam supply
Additional steam supply function is useful when
ironing folds and can only be used at high ironing
temperatures (when the iron temperature
control knob (11) is set to "•••" or "MAX").
When pressing the steam supply button (5)
steam will go out of the soleplate.
Note:
– In order to avoid water leakage from steam
openings, press the additional steam supply
button (5) with a 4-5 sec. interval.
Vertical steaming
Vertical steaming function can be used only
at high ironing temperatures (when the iron
temperature control knob (11) is set to "•••" or
"MAX").
Hold the iron vertically at the distance of 15-30
cm from the clothes, press the additional steam
supply button (5) with a 4-5 seconds interval,
steam will be supplied from the soleplate (14).
Water spray
• You can dampen the fabric by pressing the
spray button (3) several times.
• Make sure that there is enough water in the
water tank (13).
Important information
• Vertical steaming is not recommended for
synthetic fabrics.
• To avoid fabric burning, do not touch it with
iron soleplate while steaming.
• Never steam clothes on a person as the
steam temperature is very high, use hang-
ers or a stand.
Steam chamber cleaning
To prolong iron lifetime we recommend to clean
the steam chamber, especially in the regions
with "hard" water.
10
11.09.2012 14:13:29