Yamaha RX-V1300RDS Bedienungsanleitung Seite 29

5
Start playback or select a broadcast station
on the source component.
Refer to the operation instructions for the
component.
Note
• If you playback a video source that uses scrambled or encoded
signals to prevent it from being dubbed, the picture itself may
be disturbed due to those signals.
6
Adjust the volume to the desired output
level.
VOLUME
Front panel
If desired, use BASS, TREBLE and BASS
EXTENSION. These controls are only effective for
sound from the main speakers.
BASS TREBLE
– + – +
Notes
• If the component connected to the VCR 1 OUT, VCR 2/DVR
OUT, CD-R OUT and MD/TAPE OUT jacks is turned off, the
reproduced sound may be distorted or the volume may be
lowered for the characteristics of AV receivers. In this case,
turn on the component.
• BASS EXTENSION may not be effective if "1B MAIN SP" on
the SET MENU is set to SMALL and "1E LFE/BASS OUT" is
set to SWFR.
7
Select a DSP program if desired.
Use PROGRAM l / h (DSP program buttons on
the remote control) to select a DSP program. See
pages 33 - 37 for details about the DSP program.
PROGRAM
or
Front panel
0105V1300_26-32_EN-GB.p65
+
or
VOL
–
Remote control
BASS
EXTENSION
ROCK
HALL CHURCH JAZZ CLUB
CONCERT
1 2 3 4
ENTER- MUSIC TV MOVIE
TAINMENT VIDEO THEATER THEATER 1
5 6 7 8
MOVIE /DTS
THEATER 2 SUR. SELECT EX/ES
9 10 11 12
+
0 10 CHP/INDEX
Remote control
27
I BGV (background video) function
The BGV function allows you to combine a video image
from a video source with a sound from an audio source.
For example, you can enjoy listening to classical music
while having beautiful scenery from the video source on
the video monitor.
Select a source from the video group and then select a
source from the audio group with the input selector
buttons on the remote control. This selection for BGV
cannot be made with INPUT on the front panel.
A PHONO TUNER
V-AUX CBL/SAT MD/TAPE
D-TV/LD VCR 1 VCR2/DVR
I To mute the sound
Press MUTE on the
remote control.
To resume the audio output,
press MUTE again.
y
• You can also cancel mute to press any operation buttons such as
VOL +/–.
• During muting, the "MUTE" indicator flashes on the front
panel display.
• When this unit enters the standby mode, the mute function will
be cancelled.
I When you have finished using
this unit
Press STANDBY/ON (STANDBY on the
remote control) to set this unit in the
standby mode.
or
STANDBY
/ON
Front panel
2002.11.07, 12:07
BASIC PLAYBACK
CD
CD-R
DVD
MUTE
STANDBY
Remote control
27