On-Screen Display (Osd); Osd Modes; Selecting The Osd Mode - Yamaha RX-V1300RDS Bedienungsanleitung

You can display the operation information for this unit on
a video monitor. If you display the SET MENU and DSP
program parameter settings on a monitor, it is much easier
to see the available options and parameters than it is by
reading this information on the front panel display.
y
• If a video source is being reproduced, the OSD is
superimposed over the image.
• The OSD signal is not output to the REC OUT jack, and will
not be recorded with any video signal.
• You can set the OSD to turn on (gray background) or off when
a video source is not being reproduced (or the source
component is turned off) by using "13 DISPLAY SET" on the
SET MENU (see page 66).

OSD Modes

You can change the amount of information the OSD
shows.
Full display
This mode always shows the DSP program parameter
settings on the video monitor.
Short display
This mode briefly shows the same contents as the front
panel display at the bottom of the screen and then
disappears.
Display off
This mode briefly shows the "DISPLAY OFF" message at
the bottom of the screen and then disappears. Afterwards,
no changes to operations appear on the monitor except
those of the ON SCREEN button.
P01 CONCERT HALL
≥ D S P L E V E L ... ... ... ... 0 d B
I N I T . D L Y ... ... ... ... 4 5 m s
R O O M S I Z E ... ... ... ... 1 . O
L I V E N E S S ... ... ... ... ... ... ... 5
Full display
y
• When you choose the full display mode, INPUT, VOLUME
and some other types of operation information are displayed at
the bottom of the screen in the same format as that for the front
panel display.
• The SET MENU and test tone display appear regardless of the
OSD mode.
22
0104V1300_21-25_EN-GB.p65

ON-SCREEN DISPLAY (OSD)

P 0 1 C O N C E R T H A L L
Short display
22

Selecting the OSD Mode

POWER POWER
TV AV
REC
AUDIO
DISC SKIP
LEVEL SET MENU
+
TITLE MENU
TV VOL
TV INPUT A/B/C/D/E
CH CH
TV MUTE
– +
SELECT
PRESET PRESET
TEST ON SCREEN
TV VOL
–
RETURN DISPLAY
1
Turn on the video monitor connected to this
unit.
2
Press AMP to select the
AMP mode.
AMP appears in the display
window on the remote control.
3
Press ON SCREEN on the
remote control repeatedly
to change the display
mode.
The OSD mode changes in the following order: full
display, short display, and display off.
Notes
• If your video monitor is connected only to the COMPONENT
VIDEO jacks of this unit, the OSD is not shown. Make sure to
connect your video monitor to the COMPONENT VIDEO
jacks and either VIDEO or S VIDEO jacks if you want to see
the OSD.
• Playing back video software that has an anti-copy signal or
video signals with a lot of noise may produce unstable images.
2002.11.07, 12:07
SELECT
AMP
2
+
VOL
–
MUTE
3
STEREO
EFFECT
AMP
ON SCREEN
DISPLAY