Setting The Manufacturer Code - Yamaha RX-V1300RDS Bedienungsanleitung

REMOTE CONTROL FEATURES

Setting the Manufacturer Code

You can control other components by setting a
manufacturer code. A code can be set up in each
component control area.
The following table shows factory-set component
(Library: component category) and the manufacturer code
for each area.
Input area Component category
A
PHONO
TUNER
CD
V-AUX
CBL/SAT
MD/TAPE
CD-R
D-TV/LD
VCR 1
VCR 2/DVR
DVD
Note
• You may not be able to operate your Yamaha component even
if Yamaha manufacture code is initially set as listed above. In
this case, try to set other Yamaha manufacture code(s).
1
Press an input selector button or
select the component you want to set up.
A PHONO TUNER
V-AUX CBL/SAT MD/TAPE
D-TV/LD VCR 1 VCR2/DVR
2
Press and hold LEARN for about 3 seconds
by using a ballpoint pen or similar object.
"SETUP" and the selected component name appear
alternately in the display window.
LEARN
Notes
• Press LEARN for at least 3 seconds, otherwise the learning
process is started.
• If you do not press any button within 30 seconds during step 3,
the setup process is canceled. If this happens, start over from
step 2.
46
0108V1300_45-55_EN-GB.p65
Manufacturer
(Library)
LD Yamaha
TV –
TUNER Yamaha
CD Yamaha
VCR –
CABLE –
MD Yamaha
CD-R Yamaha
TV –
VCR –
VCR –
DVD Yamaha
to
A
CD
CD-R
DVD
46
3
Press u / d to select the name of your
component's manufacturer.
You will find the names of most worldwide audio-
video manufacturers in alphabetical order in the
display window.
+
TV VOL
CH CH
TV MUTE
– +
SELECT
PRESET PRESET
TV VOL
–
If you want to change a library (component
category), press j / i. You can set a different
component from the input selector name.
Library choices: L:DVD, L:LD, L:CD, L:CD-R,
L:MD, L:TAP, L:TUN, L:AMP*, L:TV, L:CAB,
L:DBS, L:SAT, L:VCR
(U.S.A., Canada and Australia models only)
*L:AMP (AMP Library)
AMP Library has 2 codes: YPC (code to operate this
unit) and ZONE 2.
4
Press one of the buttons shaded below to
check if it works for the component being
set.
If it does, the manufacturer code setting has been
correctly made. If the manufacturer of your
component has more than one codes, try each of
them until you find the correct one as checking if it
works following step 4.
POWER POWER
TV
REC
AUDIO
DISC SKIP
LEVEL SET MENU
+
TITLE MENU
TV VOL
TV INPUT A/B/C/D/E
y
• If you continuously want to set up another code for another
component, press TV MUTE/SELECT and repeat steps 1, 3
and 4.
2002.11.07, 12:08
AMP
AV
+
VOL
–
MUTE